The indicators and reverse lights don't work on my 1991 jeep wrangler. i've replaced the fuse, but it keeps shorting. My tester indicates that it's getting current. any suggestions??

SOURCE: seat belt indicator

look under the drivers seat there is a plug that may be unplugged or broken this is what tells the light to stay on plug it in or try unplugging it and see what happens, on some of the 200 and up models the seat belt light may have some affect on airbags working properly, I have not found this to be the case on 97 model.

SOURCE: Will a 1998 jeep 4L 2.5 motor work in a 1991 jeep wrangler?

Most likely yes. One thing about the older Jeeps is that they did not change the models much from year to year. If the two jeeps had the same engine, they are probably nearly 100% interchangeable.

SOURCE: "maintenance required" light is stuck on in 1991 Jeep Wrangler

On the dim dashlights, there is usually a rotory switch that you can turn to increase the power to the dash lights. In earlier vehicles it was part of the headlight switch and you just turned it one way or the other to adjust the brightness. In newer vehicles it is a switch like a knob sticking out of the dash on its side that you push up or down to change the brightness of the lamps.

The Maintenance Required light is probable on because the vehicle has hit the 50,000 mile mark and it comes on automatically so that you take the vehicle in for maint. of the emission system. If this is the case there is usually a way to reset it untill another 50,000 miles go by. I would read the owners manual, or better yet pickup a Chilton manual for the vehicle and see if it says how to reset the light. You also may want to have the vehicle checked to see if any trouble codes have been signaled. Good Luck, RAC

Marvin

• 85242 Answers
• Posted on May 13, 2009

SOURCE: 1991 jeep wrangler clutch

U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.

SOURCE: 2000 jeep wrangler, brake lights don't work

check brakelighy switch