I have a jeep liberty and i need a diagram of how to set the timming on my engine putting the cams on mark so the engine can start

This is some information on the 2,4 liter engine. The Liberty also came out with a 3.4 with a chain not a belt and it has a second chain on it as an idler so I just went with the 2.4 because you didn't mention anything else. These are the biggest I could put on here because Fixya has a size limit as to the pictures I can can put on. Bad enough I had to break it down to 10 different pictures. Anyhow, this is some of what I have. I do have the whole service manual and if you want you can email me and I will send you the entire engine section which would help you more clearly. If you do, make sure you tell me the engine size and what you are needing because i won't remember. Don't worry, it wont cost you any $$$ I don't mind helping. Keep in mind if this is the correct engine that the marks don't quite line up until after the tang is put on for the tension. My email is [email protected]. Here's some of the pictures and instructions for the 2.4. I hope this helsp and good luck.