1994 toyota pickup emergency brake warinng light and battery warining light are flickering on and off what is causing this.

If you disconnect the wire(s) coming from the switch, does the light say on? If so, there may be a short to ground fro the switch to the lamp. You would need to replace or have the wire replaced.

Plan A. - You have a switch by the emergency brake that engages when the brake pedal is on or off. There is a small round switch like item where the pedal is pressed on. You will see a button, and this button is the switch and at the other end of this button are two wires plugged in. Unplug either one and the light filckering should go away. If it stops filkering then it is either an adjustment of the switch or replacement. Let me know if this does not take care of your issue and I will guide you through plan B

there is a switch for the emergency brake towards the bottom of the emergency brake handle under the dash...........i hope this will help and if you need more info let me know and also if the switch is not the problem let me know what you have checked........i believe that you will find that the switch is the problem.......if you could let me and fixya know if i was any help to you and a thumbs up........thanks and good luck.......

It could be your spring on your emergency brake pedal is weak causing the light to go on or flicker.

The brake light usually comes on with the battery on older Toyotas as an indicator that a problem with the alternator has occurred.

look along the frame for the cable
stick a wrench in oneside and the other side turn with a wrench

Have you verified your brake fluid level in the reservoir?

Also, be sure your emergency brake pedal/sensor is secure. You may be causing the vehicle to think the E brake is on and if the E brake is engaged, all vehicles with ABS will disable the ABS system.

under the e/brake there is a switch it actuates the light, i would say that it is corroded/stuffed. take off the h/brahe surround and you should be able to see two elec wires if not the switch itself, if you just want the light off cut one of the wires and tape it up, this will brake the circuit and diable the light, or if you want it fixed properly, replace the switch. hope this has been handy.

it could mean ur low on break fluid or ur emergency brake its not all the way down.

low brake fluid or float in brake master cylinder stuck