Do you know how to test automotive electrical circuits ?
When the headlamp switch is turned to the HEAD position, battery voltage is applied to the headlamp opening door actuator control module through CKT 103. The LH head lamp door opens when battery voltage is applied to the LH headlamp opening door assembly through CKT 576 and ground is applied to CKT 577. The RH headlamp door opens when battery voltage is applied to the RH headlamp opening door assembly through CKT 578 and ground is applied to CKT 579. When the headlamp switch is moved to the OFF position, battery voltage is applied to the headlamp opening door actuator control module through CKT 306. The LH headlamp door closes when battery voltage is applied to the LH headlamp opening door assembly through CKT 577 and ground is applied to CKT 576. The RH headlamp door closes when battery voltage is applied to the RH headlamp opening door assembly through CKT 579 and ground is applied to CKT 578. Battery voltage is constantly applied to the headlamp opening door actuator control module from the HDLP MOT L MiniFuse® #4 (CKT 2940) and from the HDLP MOT R, MiniFuse #3 (CKT 3040). The headlamp opening door actuator control module is grounded by CKT 150 through Splice Pack #100 to G102.
Headlamp Doors Do Not Close
Install a scan tool and go to the BCM input display.
Monitor the headlamp off switch status.
Turn the headlamps on and off.
Does the scan tool indicate the headlamp off switch inactive and active?
--
YES - Go to Step 4
NO - Go to Step 6
4
Disconnect the headlamp opening door actuator control module connector C1.
Connect a DMM from connector C1 terminal D to ground.
Measure resistance to ground of circuit 150.
Is resistance within the specified values?
0-2 ohms
YES - Go to Step 5
NO - Go to Step 9
5
Connect a test light from the headlamp opening door actuator control module connector C1 terminal C to ground.
Turn the headlamp switch off.
Does the test light illuminate?
SOURCE: 1977 chevy corvette wiring diagram
Where do I find the fuse for dash board lights. I wish to buy a few.
SOURCE: Headlights ok, but instrument panel,fog,&parking lights don't
Maybe a relay but maybe and more probably a broken wire Get a diagram Chilton or Haynes manual
SOURCE: Need wiring diagram for 1979 corvette
Tried to reach you twice...I have the entire car diagram just need to know how/where to send!!!
SOURCE: My 1986 chevy corvette dash lights and headlights
Check to see if there is a headlight relay and check all ground circuits to the lighting system. They are both powered from the same circuit.
SOURCE: Some times when I turn on my headlights the tail
Are all your marker lights out when your tail lights are out?
1,212 views
Usually answered in minutes!
×