Where is the heater blower resistor located? - 2000 Subaru Outback

Blower Motor Resistor

Blazer Forum https://blazerforum.com > forum > blower-motor-resis...
Oct 20, 2010 - The blower motor resistor is located under the hood on top of the HVAC housing towards the center of the truck. Run a search on "blower+motor+ ...

Can't locate Blower Motor Resistor on 1998 Blazer 4x4
Jan 11, 2012
2000 Chevy blazer blower motor won't work on high!
Aug 19, 2023
New blower motor,new resistor, no power - Blazer Forum
Aug 9, 2020
2000 Blazer - Heater blower Not Turning On
Oct 25, 2013
More results from blazerforum.com
https://www.google.com/search?q=2000+Chevy+Blazer+2WD+4.3+V6.+Blower+motor+resistor

The heater blower motor resistor is located underneath the dashboard in the heater/AC compartment.


Heater Blower Motor Resistor Replacement - YourMechanic

https://www.yourmechanic.com/.../heater-blower-motor-resistor-replaceme...
Feedback

Replacing A Blower Motor That Doesn't Blow - YouTube

? 2:29
https://www.youtube.com/watch?v=4edK8fa-Ypg
Mar 9, 2011 - Uploaded by Scotty Kilmer
Scotty Kilmer, mechanic for the last 46 years, shows how you can replace a broken blower motor in your car ...

Blower Motor Replacement and More - YouTube

? 13:19
https://www.youtube.com/watch?v=2p5QYd58sTk
Jun 12, 2012 - Uploaded by talyn875
Do not try this at home. For HVAC professional use only. This video shows yours truly changing a blower motor ...

Located Usually On Front Of Engine Block About the Size Of A Quarter ( Black ) with One Wire Comiig outof it

Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Before removing the heater switch on this 2006 citroen hdi I would first have the blower motor checked and the most common reason for this and other blower problems would be the blower resistor.

Your blower works on and off at times, first locate the blower motor and the resistor. the blower motor is located on the heater box, look under the pass/side of the dash, you may have to remove under dash cover to see blower.
When you have located the blower now look to the side on the heater box, there you will see a connector plug, it plugs into a connection on the heater box, this will be the resistor, the resistor slides into heater box and the end of it bolts to box to hold it in place and then the connector plugs into it, if you can not locate it then follow wires that plug into blower , follow wires back they will lead you to resistor,
next time blower does not work wiggle connector to resistor and see if blower turns on, if it does then resistor is the problem. also unplug resistor plug at resistor and check for any burning of connectors at plug and inside resistor.

I would bet its a bad resistor or the plug is brunt due to high draw from bad connections, if plug has burn damage to connectors then replace the plug along with resistor.

It will be up under the dash on the passenger side near the blower motor. It will have 5 or six wires in its connector

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

this is for manual heater system. If you have electronic (digital display) you don't have one. Instead you have a blower motor speed controller.

here is info

Control System Outputs—Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:

• The assembly is located in the engine compartment on the evaporator housing toward the center of the vehicle.
• Three resistor elements are mounted on the resistor board to provide four blower motor speeds.
• Depending on the heater blower motor switch position, series resistance is added or bypassed in the A/C blower motor circuit to decrease or increase A/C blower motor speed.
• An overheating protective device (thermal limiter) will open the resistor coil when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
• The thermal limiter cannot be reset and is not serviceable.

sounds to me like the blower motor resistor, and if I'm not mistaken the resistor and the blower motor are located under the dash on the passengers side. the resistor should have a wiring connection and 2 screws attaching it to the blower case. The a/c and heater blower will not work if the resistor goes out. hope this helps you out a little. Best wishes.

if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Blower Motor Resistor
The four-speed operation of the blower motor is achieved through the blower motor resistor. The blower motor resistor is mounted under the A/C evaporator/blower motor assembly.
-----------------------------------------------------------------------------------------------------------------

the heater blower resister is in the heater plenum under the dash on the passenger side. the resister is in the air stream to keep it cooled. it has 2 screws holding it in and a 3 or 4 wire connector on it. easy repair. buy resister from tascaford.com for 25% off.