When I pull the gas cap release handle the cap does not open.TriBeCa Subaru 2008 model!

Pry it open?

It is related to the cam position sensor. If it has vvt timing. Low oil will affect it.

Radio volume control on 2008 Subaru Tribeca does not ...

www.fixya.com/.../t25735073-radio_volume_control_2008_subaru_trib...

Jun 7, 2015 - Radio volume control on 2008 Subaru Tribeca does not work, but remote volume control on steering wheel works. ... does not... Replace the volume control(rheostat) inside the radio. .... Oct 09, 2014 ' 2007 Subaru B9 Tribeca.

Have you checked; the fuses? The power connection? The ground connection?

The High and low beams are all in the same bulb. You have to reach in behind the light in the engine compartment and undo the retaining collar and pull it out and then pull the bulb assembly out if it separates from the collar. Unplug the bulb and replace it. I usually stop at Walmart and use the little box they have there to find the proper bulb for the vehicle, in most cases they are the less costly of the places you can get the bulbs.

http://www.elightbulbs.com/2006-Subaru-B9-Tribeca-Replacement-Light-Bulbs under car at fog light unscrew cap pull bulb out do not touch new bulb hold at bottom put back in same way

had the same problem a month ago. checked guide book, they said could be gas cap not closed properly, so checked that. no change. verified oil, realized had only a pint of oil left! concluded that using sportshift uses lots of oil, so will go easy on that now. its a goos suv, but not a sports car. All lights were off after a few starts the next morning. no problems since. When i went to dealer, he had no advice or idea a about that. All they know is show me the money !

Hello SUBY bro, kick me if I'm wrong but imho this should not be that complicated to require a schematic......Below is the reply I posted here on FixYa for another 08 Tribeca owner......Peace

We have an 05 Legacy and I've done this. Tribeca should be the same way: Look through the engine bay behind the light, you can locate the position by following the wires which actually connect to the bulb assembly. The bulb assembly ought to be removable with a 1/4-1/2 turn and pull motion. Be sure to not touch the replacement bulb with your bare hands. Your Subaru service ought to help you with this and not charge you......

http://www.cars101.com/subaru/keyless.html this site has a lot of info on the car and a coding system which might turn the error off :D