Would like to replace the starter on my 1991 lexus ls400 and I was told that in order to get to it, the intake manifold will have to be taken out and the starter pulled from the top. However, ai was also told that by removing the heat shield for the exhaust manifold below that you could also access the starter from below. Is this correct? and Is it also possible to access it from below without taking out the intake manifold above?

SOURCE: need replace head light bulb

open the hood then look down ont he side that is blown there should be a black rubber boot covering the light look for the wiring then slide the boot back release the sension clasp and pull it out replace and reverse the process to put everything back togather

SOURCE: radio locked 1991 lexus ls400

Consult your owners manual--in the radio section there is a master code listed---use that then reset the radio with your own code---

Mike Vincent

• 358 Answers
• Posted on May 21, 2009

SOURCE: R & R 1991 Lexus Ls400 Gear shift knob

slide the lower part of shifter handle down and you will find two screws, but there is 2 wires coming in from center console for overdrive button.you have to remove the center console cover and remove the 2 wires from connector and then pull up threw handle.when you go back together you will have to guide them back threw the handle.

SOURCE: Replace/fix starter on 1991 Lexus LS400

Not too bad. Not much room, just enough to drop the starter. It is probably easier to go up through exhaust if you can get your exhaust shield off the manifold .

Johnny Brown

• 5763 Answers
• Posted on Mar 01, 2010

SOURCE: how to change the fuel pump on 1991 lexus ls400

remove rear seat then remove cover in the trunk, you will see a cover remove thatcover and remove 8 bolts holding fuelpump in tank,also dissconnect connector to fuelpump with bolts removed the pump pulls right out.hope this helps.