Hi my break light do not good i need to change de fuse but i dont know hich one is it pl can u tell me tks

Turn signals are on fuse number one and brake lights are on fuse number 9. Both are in the fuse box under the dash or on the side of the dash. Both are 15amp.

If you are sure that the bulbs are not burned out then you need to test the socket to make sure they are getting power. If no power at that point then you are looking at a bad socket, wire or fuse.

Check if hi mount brake light works. if so ck bulbs.if not, ck fuse/ switch If switch was bad, I dont think you could get it out of park. Dont disconnect battery.

i do not know about the camry but my truck brake fuse was under the hood, I used a tester,that cam with the fuse kit, til I found the blown fuse. Hope this helped Tim

looking at a fuse is no way to tell if it is any good or not.it must be checked with a test light as there could be a small break in the fuse that you can`t tell by looking at it.i`ve even had one were the test light should a good fuse but when tested with a ohm meter with the fuse out of the fuse panel across the prongs it checked bad,it had a break in the section of the fuse that you can`t see through.

I was checking the fuses on my Dodge Caravan a few days ago and the information on circuits was printed on the inside of the fuse-box cover...........just in case your fuse box has a cover and the same setup. Good luck.

take it to a workshop that either can repair automatic transmissions or manual transmissions, i dont know hich because you dont say what type of gearbox you have. If its a manual, then is the clutch faulty ? if its automatic then do you have any oil in the gearbox ?

Did you check the glove box for fuses? There is a switch in the steering column too that could be the issue.

all you need to do is buy a cheep test light in the 5-10 range. ground the test light and touch the metal in the fuse you do not need to take the fuse out. check both sides of the fuse you will see 2 metal pices on the back of the fuse were it tells you how many amps the fuse is. that is what you touch with the test light. the light should light up if not the fuses are bad. if the fuse is good take the test light and ground it again you can clip it to the side of the cig lighter socket. and put the test light prob into the cig lighter socket becarefull not to touch the sides of the socket and just touch dead center bottom and if the test light does not light up you know your Cig socket has burnt out

check the brake switch located on a bracket under your driver side, on top of the brake pedel check for power, if power depress on your pedal see if there's nopower on the other side of the switch then replace the switch. I think it is the switch.