I have an 05 Hyundai Tiburon GT and the top side mirror housing is loose, but the whole housing is attatched to the door of my car. How can I tighten the top housing that holds the mirror?

May have to pull inside door panel to do it. Check with hyundai

If you try to start the car but only hear a clicking sound when turning the key, then its the selinoid. Replace it. Located as a small tube housed next to the starter motor. Starters can be overhalled depending on its internal condition and if it is not a sealed type. Replacing the bushes and brushes.

the triangel cover on the inside towards the front of the door. pop it off and youll see three 10mm bolts that hold the whole housing to the door.

follow the top radiator hose to the block it is located in the housing at the end of the hose.

first obtain a replacement .the cover with tape to prevent shattering the glass then carefully prise of the glass with a screwdriver refitting should be just a case of cleaning any glass away and removing adhesive tape and refitting the glass the heating element is part of the housing and the heat should just transfer through the glass ..not a hard job ..just tricky and time consuming ..if the housing has been damaged .then its a bit more difficult ..first obtain a replacement and then remove the door card then the fixings should be visible remove them and the mirror housing should come loose remove any wiring from the loom then fix the new unit connect any wiring then refit the fixing screws and then replace the door card ..again not the most technical but of work but time taken will show in the end result ..dont loose you temper as it is a bit fiddly ..if in doubt get halford to do it for you or any other similar garage

Hi There,

You will find the second fuse box on the right hand side of the steering wheel (australian - left hand side if in america) located underneath the power "mirrors" button. Follow the side power "mirrors" button down until you reach a false wall, unfasten this. another word for this is the "fascia"

Hope this helps

Cheers Buckaroo,
Chris

There is no such thing as a 'driver side door sensor' on a 2001 Hyundai Tiburon.

You must remove the entire headlight housing assembly. Should be about four nuts on studs depending on what side you may have to reomove the battery. you will a 10 mm wrench or deep socket. the light socket then twist in and out and you splug in the bulb once you get tho that point it is prety simple.

there should be a plastic cover on the inside of the car where the mirror is take this off and there will be a connector block unplug this and there should be screws undo them and the whole thing should come off themn and you should be able to seperate them then.