How do you remove outer lt. front door handle from audi q7?

Question edited for clarity, year make model.
Question moved to Audi Q7.

Audi Q7 (4L; 2007-2015) fuses and relays

https://fuse-box.info > audi > audi-q7-4l-2007-2015-fu...
Here you will find fuse box diagrams of Audi Q7 2007, 2008, 2009, 2010, ... Assignment of the fuses and relays in the engine compartment (diesel engine) ...

Fuse box diagram Audi Q7 and relay with assignment and ...

https://fuseandrelay.com > audi > q7
Description of fuse boxes and relays Audi Q7, their locations and diagrams. ... V12 TDI: Coolant circulation relay after off. engine -J151- (V6 FSI from ...
‎Passenger compartment · ‎Front right fuse box · ‎Relay and fuse box in the...

Fuses and relay Audi Q7

https://fusesdiagram.com > audi > fuses-and-relay-audi-...
For the Audi Q7 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 model year. Cigarette lighter fuse - (fuse box in Right cockp it : fuse panel, fuse ? ...

If all bolts and door handles have been removed the panel is now held in place with clips. Carefully go around it and using a flat bladed screw driver pry it off.

Remove the door trim panel and replace the switch. You might be able to push up the switch from the door armrest from the hole below and in front of the armrest. Google the assembly pic. Or buy a Bentley EBahn CD and get access to EBahn Web.

check arm rest for screws,remove door handle ,check for screws or clips around edge of trim,prise off carefully with a screw driver.

how to remove the front bumper on a audi q7, as replacing my SE model front bumper with a S-line front bumper. and vidoes or instructions much appreciated.

There is a key barrel on the boot handle. Then use the key blade placed inside the key fob under bottom cap. Just remove the cap.

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can disconnect the linkage connecting to the outer handle and remove the bolts securing the outer handle on

you would have to try and remove the door panel if possible and find the rod that controls the latch and open the door.

Ok
Remove plastic plug on the inside of door there is 10 mm hole use a hooked pick set pick put through the hole and pull the plastic cir clip towards the back of the door that will release the smaller part of the outer handle then the handle itself can be taken out.this is so simple but so deceiving the actual cir clip is hard to notice because of all the plastic **** on the inside backing plate the cir clip is just on the inside of hole look hard it is 2mm thick & 20mm high (black plastic) place point of pick in between backing plate & cir clip hook it and pull back the front door is based on the same principle but is a lot easier

You need to use a small hook. Push it into the hole on the inside of the door where the round bung is. Push forward on the plastic so it moves towards the front of the car then turn the hook towards you and pull back it shoould move a slide so you can remove the handle extension, you dont have to remove the colour coded cover from the outside.
Hope this helps.