On you throttle body you will find the tps ( throttle position sensor) there is waires held on by clip remove the clip,
then there will be 2 screws one on each side(#10) they are star bit. un screw them and replace the pts. this is a common problem with dodge rams from 1986 threw 1990 dodge was a ware of the problem and changed how the sensor was made.
SOURCE: 1990 Dodge 250 2wd trans fit 4x4 1988 Ramcharger
if you are talking about the trans no! the 2wd trans has a longer output shaft than the 4x4 you can have the shaft changed so that it can work if you are having trouble finding a trans.
SOURCE: 87 dodge ramcharger not firing
Pull the coil wire out of center of distributor cap and lay it close to where you unpluged it from distributor cap, and turn over engine if coil is good you will see the spark jump. If no spark coil bad.
SOURCE: ballast resistor location
should be on the firewall...can't remember which side but I think its on driver side It's ceramic rectangle with four wires. (I had one and just can't picture where exactly it was.) One tip though, when you put it back on, use some high temp silicone around top and side edges, leave bottom open. They usually fail from water dripping down and cracking resistor (gets hot).
SOURCE: i have an 88 ramcharger, with a 318. trans slips
sorry but there is no adjustment for slipping,the only adjustments are for band adjustments.
197 views
Usually answered in minutes!
Could you please confirm whether it is a carburetor or fuel injected version?
Fuel injected
×