How to replace brain box of audi A6 1996 model

Albert Getty

• 547 Answers
• Posted on Feb 11, 2009

SOURCE: HI , Where is the fuse box on a 2006 Audi A6 ?

hi there are 3 places it could be 1 under dash 2 on drivers side stand outside car looking to the left of stearing wheel 3 under hood in a blackbox

SOURCE: fuse box in a audi a6 1995

Fuses are located by the side of the dash board when you open the driver's door. The fuel pump fuse is situated in there.

SOURCE: Difference between Audi A6 1.8t engine and 1.8 engine

on the 2001 models:
1.8 - 125bhp
1.8t - 150bhp
1.8t - 180bhp

the only difference in the two turbo models is the ecu setup

SOURCE: audi A6 door mirror

roll down the window. and take the interior panel off. on the inside of the door at the morror there is a plastick cover that clips out(remove it) there is foam on the iside remove that aswell. you sould see a bolt or a skrew once loose the mirror will come out. while loosening it hold the mirror in your free hand they some times just fall off.

SOURCE: Removing the door panel to a 1996 Audi A6 Quattro

This info is wrong, remove the screws at the top of the panel along the edge ( one on the hinge edge and one on the latch edge. Remove the cover from the interior door handle by locating the hole on the bottom edge of the handle, insert a punch to release the cover, once the cover is released remove the 2 screws holding the handle on. Remove the handle.Once the handle is removed take the black trim piece that the handle seats into off. Pull the interior latch handle forward enough the remove the cable. Remove the latch handle. There is a small hole in the vynal under the latch handle, the last remaining screw that holds the panel on is inside this hole, remove it. The hole is hard to see, this took me several hours to find not knowing it was there. Remove the window switch module by sliding a screwdriver under the edge that faces the latch end of the door, push in the metal clip and pry up on the switch assembly. there are 2 plastic tabs that hook into the arm rest on the hinge end, that is why you must pry up from the latch end. Disconnect the plugs from the switch. Now you are ready to remove the panel. grasp the panel through the hole for the latch handle and pull up about 1" the panel should com free from the door. Do not pry the panel out from the door or you will break the plastic tabs that hold the panel on. Once you lift the panel up and off the door you will need to disconnect 2 electrical connectors and remove the white foam plug that seals the window switch harness into the arm rest and remove the window control wires from the panel.