Turn signals don't work, changed the burnt fuses. Where is the flasher located. is it square

in ur fuse box u should have either round flasher or square one's,they are silver in color. when they go out nothing will flash.they just plug into ur fusebox.

First check for a blowin fuse for them. If the fuse is good ,You need to change the signal light flasher.

Do your flashers work? If not it may be the flasher unit is bad. It is located under the dash on the drivers side on or near the fuse box. If the flashers work you may have a problem with the turn signal lever or the wiring connected to it.

might be an inline fuse

Have yoiu changed/checled the lightbulbs? (In other words,do your turn signal lights work? If the front turn signal lights work, but the rear don't, then turn on your four (4) way flashers. If the rear lights still don't work, then all the bulbs are bad. It is rare for all the bulbs to be burnt out at the same time, but it does happen.

If the turn signal/four way flasher lights work, then you probably have a bad brake light switch. However, first check your owner's manual to make certain there is not a separate fuse for these lights. If there is, then swap the fuse for the brake lights for another fuse (or relay) of the same size/amperage. (Facing the hood, the power relay box is located on the right side (usually) under the hood.)

The fuse box is located under the dash, on the driver's side of the car. Usually there is a plastic cover that has to be removed to access the underside of the dash, and then there is a plastic cover that has to be removed to access the fuse box. If you don't have an owner's manual, nprmally the fuses and power relays are normally marked on the plastic covers your remove ot access the fuses and power relays.

If the fuses/relays are good, then you have a bad brake light switch. This is located on a bracket just above the brake pedal. When you push the pedal down, the switch makes contact. Disconnect the plug to the switch, and jump across the plug contacts (not the switch) with a small piece of wire, or if a piece of insulated wire is unavailable, you can use a paperclip, you won't get schocked, just make certain that the paperclip does not come in contact with a ground while you have it plugged in to the plug for the brake light switch.

If the lights stil dont work, check for power to the plug for the brake light switch. If you have power to the plug, the turn signals and four-way flashers work, then my guess would be that you have a broken power wire (probably iside the steering column, or a bad turn signal switch. If the brake lights work whe nyou jump out the brake light switch, then the brake light switch is defective.

since you know where the fuses are, you also know where the flashers are. the flashers are the same part so unplug the one for the emergency flasher and put it into the socket for the turn signals and vice versa. if the signals now work but not the emergency flasher you know to get a new flasher unit at any parts store. the flasher units are cubes about an inch on each side plugged into the fuse panel.

check your fuse box for fuse burnt out, but most likely your signal light flasher switch is out, and needs replacing. Check your manual it will tell you where your signal flasher is located, it is a real easy part switch and not very much $ for just a flasher, normally under 20 bucks at auto parts stores. let me know if this helped you. Thanks Mike

you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.

There is a turn signal flasher under dash...most have a flasher for the emergency signals and one for the turn signals...some have one flasher....but check fuses first...normally it is fuse burnt...if you can locate the flasher normally they will get abnormally warm when bad......it should look like a round or square silver shiney or black cube.........if these are good with ign.on hold turn signal lever down firmly ...if it works replace turn signal unit.....if none of this works you have to troubleshoot wiring...
...normally yellow wire is left turn and green wire is right turn...black or white is ground red is stop light....but normally it is a blown fuse or flasher.

under the dash on the driver side there is a round or square sliver box that should say turn signal or flasher on it in the fuse box.