Hi, the tire pressure monitor detects any changes in the tire inflation pressure.
Therefore, it must initialize and store it in its memory if the tires
or wheels have been replaced, re-inflated or the tires have been
rotated. You can re-initialize the system by following these steps:
1. Check and make sure that your tires are inflated to the correct pressure
2. Turn the ignition switch
to the ON position. If the low tire pressure warning light comes on,
push and hold the tire pressure warning reset switch (in the glove box)
until the warning light turns off and then release the switch.
3. Now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.
4. Initialization is *not* completed until driving at the vehicle speed
of 19 mph or over for more than one hour. the tire pressure monitoring
starts when initialization is completed.
I've been looking around for new tires in Abbotsford. Do you know a good place to get them?
×
SOURCE: run flat tyre warning light is on i have checked tyre pressure
This will only come on when a tyre has dropped in pressure (not spare). It work on the principle that a tyre with less air has a smaller rolling circumference and therefore a different wheel speed. This is then monitored against other signals from other wheels and determined that a loss in pressure has occured.
If all tyre pressures seem ok, there could be a chance of a small unoticeable leak and would require a bath test. This is when the tyre is dipped in water and bubbles would appear where the puncture is.
Ultimately the system may just need to be reset, or has incorrectly been reset from a tyre change. For this you just press and hold the TPC button (located on the centre console above the gearstick - looks like a flat tyre with an exclamation) turn on the ignition to position 2 and the light will come on re then yellow,go out, come back on yellow. When it comes back on yellow it re-initializing the system. You can let go of the button and after 20 odd seconds the light will go out for the final time, completing the reset.
If the light continues to come on after the reset then you definitely have a puncture somewhere!
Hope this helps!
SOURCE: What is the correct tyre pressure for a small Nissan Lucino?
should be a sticker on the door jamb on either the drivers or passenger side door that gives you that information
SOURCE: I have a CLK200 Convertable with tyre pressure warning on
The light is coming on because ither your tires need to be checked for an under inflated tire, or your pressure sensor inside your tire is bad. Any major tire shop should have a reader to tell if you have a faulty sensor. Your tire pressure that the factory reccomends should be located on your driver's door or door frame on a sticker tag.
SOURCE: correct tyre pressure for a Daihatsu fourtrak
one the side of the tire there are one code saying max tire pressures.
SOURCE: Tyre pressure loss warning indication how do i
Insert key don,t touch brake/clutch pedals
Press start button
Use scroller on top of indicator stalk,push up/down utill you find reset
When you find it press and hold button on end of stalk
You will see reset
This is for 3 series without sat nav,if you have nav re post as it is a different reset
2,226 views
Usually answered in minutes!
×