How to reset change oil sign - 2007 GMC Sierra 1500

Low oil pressure, oil pressure sending unit, too much oil, oil change due, oil change light reset????

have you changed your oil? If its new then just reset the computer/ diagnostic screen between your RPM and Speed. Press the screen button until it reads "setup menu, Hold reset" now hold the button until the screen changes again.

press the button until screen reads "system check, hold reset"

press and hold the button. It will start a basic system check,

First check is for oil, it will read the percent of "good oil left" and say "if new, press and hold reset"

thus press and hold reset, and the computer will reset your oil life to 100%.

after any service,minor or major the thing needs to be reset.in uk the reset is done on the ecm(electronic control module...)not diy.

The wrench on your dash board means that maintenace is required. if your oil is at 15% it is time for an oil change and the tech that changes your oil will reset the light.

scroll through the diagnostics using the up and down arrow in the right side of the radio till you reach the percentage of oil left then hold the CLR button which is the circle inbetween those arrows till it resets.

Courtesy of http://synthetic-direct.ca
To reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the Message Center, press the SET UP control to access the System Check mode. Press and release the RESET button to display “OIL LIFE % HOLD RESET NEW” is displayed. Press and hold the RESET button for 2 seconds until “IF NEW OIL HOLD RESET” is displayed. Press and hold RESET button until “OIL LIFE SET TO 100%” is displayed

I had the same problem I believe.....
Changed the spark plugs and at the same time I changed the oil & Filters, (Oil & air ). You may not need to change the air fliter, But mine needed it. With the step buttons on the overhead, I could not find any reset. (my check engine light staied on) I'm no Darn Computer geek & frustrated easly by them. LOL ....So I disconected the battery cable, ( waited 15 to 20 sec) then reconnected the cable and this resets the computer. No more worning signs.
You may just need to change the oil & filter and reset the cp. Hope this helps
RC

To reset go to screen where it says the oil life percentage. Have the car off but in the on position. Press the odometer button (same button to get to the oil life screen) in and hold for a while, something like 30 sec or so until it starts flashing...Then let go and push the button again and hold and after like 5 seconds i think it will then display 100% and that's it. Hope this helps you, good luck!

WHILE HOLDING LEFT ODOMETER RESET BUTTON TURN KEY TO POSITION 1, HOLD FOR 5 SECONDS , SIGN STATING OIL- INSPECTION RESET, ETC SHOULD APPEAR , LET GO AND HOLD AGAIN, A SIGN WILL FLASH, PRESS THE BUTTON THIS TIME.

I T BELIEVE IT WILL WORK OUT.

Hi,
Hold the reset button in for 5 seconds.

You should then get a message the the "oil" life is 100% or the oil change required light will go out.
I hope this helps.
Good Luck.
Rick