How to change an odometer from miles to kilometers

There is no fuse for just the odometer, has main fuses for the whole instrument cluster . Odometer not working? instrument cluster problem. Have it checked by a professional repair shop.

Odometers
Each instrument panel cluster (IPC) is equipped with a season odometer and 2 trip odometers. The IPC uses the odometer rolling count message from the powertrain control module (PCM). The rolling count value is determined by counting the speed pulses from the vehicle speed signal (VSS). The IPC uses the rolling count data from the PCM and a software program to determine vehicle mileage. The odometers can be displayed in miles or kilometers. The units displayed is switched between English and metric by pressing the menu button on the driver information center (DIC) until the units mode is displayed. Pressing the set/reset button will select between English or Metric. . When the set/reset button is pressed to show the odometer in metric, km and the number will be displayed. When the odometer is in English, MI and the number will be displayed.


Season Odometer
The season odometer displays the total accumulated miles or kilometers of the vehicle. This value is permanently stored in the IPC. If an odometer malfunction occurs or if the IPC must be replaced, an authorized Delco service center must be contacted to program proper vehicle specifics, including mileage, for the IPC. The season odometer is capable of displaying 999,999 kilometers or 999,999 miles depending on units selected. Leading zeros are not displayed. The display will not roll-over to 000,000 if the maximum displayed miles or kilometers are reached. If the display limit is exceeded, the maximum value (999,999) is displayed. If the mileage is above 621,503 miles and metric units are selected the odometer shall display 999,999 km.


Circuit/System Testing
Ignition OFF, raise the vehicles drive wheels.
Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
? If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.
Verify that the odometer is operating properly.
? If the odometer is not operating properly, replace the IPC.

Here is an example of miles to kilometers

mi -> kmkm = mi * 1.6093km = 107.098 * 1.6093km = 172.36
or kilometers to miles
km -> mimi = km _______ 1.6093mi = 107.098 ________ 1.6093mi = 66.548

There is a e/m button on the dash by the mode and reset buttons that switches the odometer from english to metric or vise versa.

PUSH LITTLE BUTTON ON ODOMETER

yes there is a button you push it in and it changes from kilometers to odometer, should be in front of closter on the right side, right side of steering wheel.

Try pushing and holding the reset odometer button for 3 seconds.

You will need to contact VOSA (Vehicles operating standards agency) on 0300 123 9000, they should be able to inform you on the steps they need to take forward with you in order to have your MOT certificate rectified.

Push and hold the reset button, this should give you the option the change the settings.

If your colorado has a drivers info center you can do it through the dash yourself. It will be in the owners manuel. If it does not have the info center you will need to take it to a dealer and it will take just a few minutes to do with their scan tool. Good Luck

there is a button on the dash, it says ENGLISH/METRIC, push it.