I have a Isuzu Mu Wizard from 1992 with gear problems. The box is automatic. When I put it in the lock I seem to have the box locked. the box makes a lot of noise when locking. What do I do to solve it?
SOURCE: Hyundai Overdrive wont engage
It is not suggested strip and twist wires. Better take it to an authorized service station to check what causes the problem.Is it OVERDRIVE SWITCH or CRUISE CONTROL MODULE faulty?
Over drive switch has three points. (5 to 4 selects "ON" or 5 to 6 selects "OFF").
Right click on following schematic, "save picture as" to a location in your PC so you have a ZOOM IN view.
CRUISE CONTROL SYSTEM SCHEMATICS
SOURCE: 1997 isuzu wizard mu check light
Code 24 is a vehicle speed signal sensor fault, the sensor most likely does not provide a useable signal until about 25 MPH, when the computer doesn't see any signal after that speed it turns on the light. Make sense?
SOURCE: 93 isuzu bighorn
a temperature sender located at the thermostat housing was found to be faulty sending permanent earth to tranmission making the overdrive gear inoperable . when replaced the vehicle achieves 100kph from 2500 rpm as true.
SOURCE: adjusting the auto kickdown on a 1994 Isuzu Mu 3.1 Deisel
there should be a cable that runs off the throttle body
SOURCE: OD on Auto gearbox goes into neutral when cold
You need to have your transmission serviced. The fluid has gotten so thick in there that it builds up too much pressure and your transmission will either kick it out of gear or blow up. I'm glad it actually still works. Once the oil warms up it thins right out and it works no prob. Just service your tranny, and you'll be fine.
Hightower
764 views
Usually answered in minutes!
×