Oldsmobile AC resistor location

alero's had a persistant problem of ac condesate building up inside heater box and rusting the blower drive motor shaft to the point it wont turn anymore id get a look at this first. if fan wont spin free with your fingers all them other parts arnt going to help you

It is located in the low side line, this line is the larger of the two AC lines from the AC compressor.

Hi i just replace a fuel filter on an Alero 2001 4 cylinders and the fuel filter was located in the middle, kind of between de two rear wheels, i hope this could help some body, god bless you.

either the fan motor is bad or the fan resistor. get a test lite and unplug the fan motor probe the hot side of the plug while turning on the fan switch if it lites up the fan is bad if it doesnt most likely the resistor

The blower motor resistor is bad.It is located on the passengers side by the blower motor.You will need to replace it.Just follow the blower motor noise when is is on and you will find the resistor very close to the blower motor.The wires from the blower go to the resistor.This is a common problem for most makes.Hope this helps.Good luck.

Are you replacing it because it has no speeds and doesnt seem to work? checked your fuses and tried replacing the blower motor resistor? I would try a blower motor resistor because it is the most common issue with most cars first. before doing the fan, if you are unsure locate your blower plug in and apply power and ground and if it comes on it is not the blower motor.

first go to a shop so they can vacuum what r134 is left in the system. . Then go home and replace it. Then go back to again to make sure you now have no leaks. Then they can fill it up .

Pull the engine accessory drive belt off and check the pulley bearing and the nose of the water pump and AC compressor for play, this may be the AC compressor pulley bearing or the water pump pulley bearing

Blower for heat is usually behind the glove box, and you have to deal with the dash, sorry

Not sure what you mean by the sensor. There is a package of resistors located at the front left side of the passenger position on the center console. My blower wouldn't work in 1 and 2 speeds until I replaced this resistor