I have a 1996 honda accord 2.2 vtech 4 cyl... i recently head my water pump changed head gaskets replaced...and now i have my oil light bleaking its been on for about a month now...its not low on oil it is leaking a lil by the distrubator some one told me it couldnt be that that its my vtech solenoid can anyone help me???

SOURCE: i need 1996 honda accord speed sensor plug wiring diagram

Diagram is courtesy of honda

[IMG]http://i34.tinypic.com/10wjogi.jpg[/IMG]

SOURCE: oil leaking on 95 honda accord ex

i would check the oil plug screw seal first before i would do the valve solenoid/pressure switch. also, if the oil plug screw seal is fine and tightly screwed in, it may just be the switch seal itself.

SOURCE: how to remove valve cover gasket on a 1998 honda accord

try removing the bolts hold on the valve cover and once you do that take a razor blade and a little lube and careful scrape the old one off.

SOURCE: transmission would not shift from first then

I don't know if this will help but I 'll give you my experience .... I have a 90 accord ex 2.2 l ( love these hondas) and my s light kept flashing .... I bought a book , took it to honda of fife they said i needed a new computer 750 bucks yaeh right....... I did some tweakin under the hood and found a broken transmission solenoid sensor wire and fixed that and noticed my tranny fluid level was a quart over full, so i drained some out.... used an ohm reader and found one faulty temp sensor of 4 or 5 , changed that (the main one for the fans) anyhow I am almost certain all my troubles stemed from the computer getting the over full signal or the faulty tranny solenoid reading..... now everything is top on it .... but before the computer kept me locked out of half of my tranny, ...........