How do you advance the timing on a 2000 kia spectra

as per kia no will not fit ------notify dealer --junkyard-or online search search2000-2004 Kia Spectra Lamp-Room Part Number: 0K9B051310B06
Vehicle SpecificOther Name: Lamp Assembly-Room; Dome Lamp Assembly, Overhead Lamp Manufacturer Note: INT;DD2Replaces: 0K9B051310B05 fits only the following Kia Spectra Years:

• 2000-2004 Kia Spectra' Low Grade, Middle Grade' 1.8L' 4 Door Seda this is one of the many catalogs https://www.factorykiapartsonline.com/?gclid=EAIaIQobChMIlpvVlsCS8wIVyGpvBB0xKgw7EAMYASAAEgLIHfD_BwE

https://www.google.com/search?q=2000+pontiac+firebird+wiring+diagram&biw=1363&bih=650&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwjjwNyt4MTQAhXDSyYKHTlhAxYQsAQIKQ#tbm=isch&q=Does+an+04+kia+spectra+have+rear+wheel+bearings%3F

Hope this helps

Hi Frankie,here's a video on replacing your timing belt,it is a Spectra,but the engine is the same as yours. Kia Spectra Timing Belt Replacement 1 8L DOHC Engine Part 1

Check this website

https://www.autogenius.info/category/kia/kia-spectra/

The oil filter is located about mid way on Left side of the Block. To see its diagram and replacement,instructions, Click the link below:---
http://technoanswers.blogspot.com/2011/10/how-to-replace-oil-filter-on-2002-kia.html --------- This should help.Thanks.Helpmech.

physicaly you cannot it can be done with the dealer software or one of these so called tune up rally programmes but they dont always work as it depends on the market where the vehicle is sold as europeon software is encrypted

may have a vacuum leak, check all vacuum hoses and connections that may have accidentally came off during latest repairs, Tim

Hi Po0011 is not a valid code but if you meant P0011 then it refers to an over advanced cam timing fault.

John

its in the dashboard

this should be the info your looking for.

remove timing cover, on the left cam sprocket(closer to inside of vehicle) you will see the letter (I)for intake and a notch above it on the valve cover align those marks.Next on the right cam sprocket you will see the letter (E) for exhaust and a notch above it on the valve cover align those marks.Last you have a notch on your crank sprocket, align that notch with the arrow just above it.Align all marks then turn belt to revolutions and see if marks are stilled aligned if not try again until you get it right.If so put everything back together and "happy driving!"

Let me know if you need further assistance ok