Question about 2004 Pontiac Bonneville
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
There is only one screw to remove that releases the mounting tab at the upper inner corner of the assembly. That screw has a plastic wingnut molded onto it so you can turn by hand. Once that is removed, the assembly can be pulled straight forward. At the inner bottom corner, a spring clip faces straight rearward. Pull with enough force to to release the clip from its slot. Only two "Fingers" hold the rear of the assembly in the sheet metal holes.
Posted on Nov 15, 2008
if you look by the crankshaft pulley to the right you will see a tubular looking shaft about 1" diameter , you will notice you can't get the belt out from under this piece , it has a nut on it , once you take the nut off , you will notice it has a star shaped point on the tip of the stud , it requires a reverse torx socket or wrench to remove the stud , when you get the stud out the tube piece it can be removed , then the belt comes off , replace the belt , now comes the tricky part , fitting that tube spacer back into its spot , it can be difficult , once its in place put the stud back in , and put the nut on and tighten it , your pretty much a pro now . thanks.
Posted on Dec 30, 2008
SOURCE: Headlamp assembly on Pontiac G6
well there isn't much on gripping the retainers, what they are, are plastic ball and socket clips. I would lay some tape down underneth the lamp onto the bumper to protect the bumper and then the hard part...while making sure the headlamp is above the bumper, pull with some force on the back half of the light to where it meets with the fender, after a little pulling it should (no promises) should come out, it will seem like it will break but it shouldn't. (I use to work at a body shop and did many of those headlights including my own '06 G6.) Hope that helps.
Posted on Dec 31, 2008
There are 2 bolts on the top corners of the bulb lens that needs to be removed then the lens pops right out and you can change the bulb.
Posted on Apr 06, 2009
you have to remove the marker/signal light assemblies by prying them forward, careful of the paint, they are held on by clips
Posted on May 11, 2010
Tips for a great answer:
Aug 02, 2014 | 2004 Pontiac Bonneville
Jul 12, 2013 | Cars & Trucks
May 03, 2012 | 2003 Pontiac Bonneville
Jul 06, 2010 | 2004 Pontiac Grand Am
Jun 14, 2010 | 2005 Pontiac Montana SV6
Feb 14, 2010 | 2004 Pontiac Bonneville
Jul 01, 2009 | 1989 Pontiac Bonneville
Feb 08, 2009 | 1996 Pontiac Bonneville SE CA Value
83 people viewed this question
Usually answered in minutes!