SOURCE: Black clamps for rear seat? Where do they go?
There are 2 small kinda u shaped clamps that sit on the floor. Those are used to hold the seat down to the floor of the car. You set the seat down and push it in toward the back of the car as well as down at the same time to lock it into those clamps. If you look up near the edge of the area where the seat goes you should see the holes for those brackets.
SOURCE: 2004 hyundai accent. trouble filling gas tank
The fill tube for the fuel tank is either clogged with something or the anti-siphon feature (what stops people from stealing your gas) is fouled up. The tank and fill tube have to be inspected.
SOURCE: Speedometer Needle for Hyundai 2004 Accent
If your transmission fluid level is okay, then you need a new speedometer cable. Its not terribly difficult to replace, but it does require you to pull the instrument cluster. A local Hyundai dealership might be willing to photocopy the specific speedometer cable replacement instructions out of the 2004 Accent shop manual.
SOURCE: Rear struts failed after dealer put car on lift.
you have a reason to be doubtful. very seldom would something like that occur unless the srut was near it's peak functionming and starting to fail. the strut is always under pressure because of the spring so " not meshing sounds bogus to me. i have been a mechanic for over 20 years and i can't give you one example of this happening on your model of car or any other models. to be quite honest a strut that fails only after 4-5 years very seldom happens to begin with. but does happen. my advice is to take it to a small shop whjere the quality of work is better and the cost cheaper and have them examine it. let me know what they say and get back to me. just click my user name on this site i will be more than happy to help you further if there is more questions that you have
SOURCE: Replacing bulb (Headlight) in 2000 accent GL
once you pop the hood, there should be a cover behind the light housing that you twist to open the backing.. inside the housing will be a spring lever that secures the bulb down... unhook the spring and disconnect the harness connecting to the bulb...
138 views
Usually answered in minutes!
×