How can you bypass the factory alarm so you dont have to double click your remote to start the car.

To arm content theft alarm.
1. Open the door.
2. Lock the door with the power door lock switch or
the remote keyless entry transmitter. The
SECURITY light should flash.
3. Close all doors. The SECURITY light should go off
after approximately 30 seconds. The alarm is not
armed until the SECURITY light goes off.

If a locked door is opened without the key or the remote keyless entry transmitter, the alarm will go off. The headlamps and parking lamps will flash for two minutes, and the horn will sound for 30 seconds, then will turn off to save the battery power.

Take a look at www.crutchfeld.com, in the remote start section. They have bypass modules.

sounds like a bad or dead battery..

if you unlock the driver door before opening it with the key you can turn the alarm off. Also taking it to a electronics place and having a keyless entry system will bypass the factory alarm as long as you tell them to hook it up and in most cases its less than buying a new factory remote. Also if you dont lock the car with the lock button from the driver door before you close the door the alarm will not arm.

get pro back to sort it

you have to use the key to unlock and lock a door.that is if its a factory alarm. after market add on may not work that way and may need the remote. if drivers door dont disarm it try the key on pass. side. doors have to be closed when lock/unlock with the key

In order to 'RESET' burgular alarm, you MUST have the remote keless entry fob programmed for the vehicle - no other way unless you want to bypass/disable the burgular alarm relay and alarm horn. This, however, does not disable the 'flashers' when the alarm is activated. Bypassing the relay will allow you to start the engine, but you'll be driving around with your parking lights flashing.

If this is a factory alarm all you have to do to turn it off is put your key in the door ,lock it then unlock it . if its not a factory alarm you will need the remote or have the entire alarm unhooked by a mechanic

Order and program a new remote.http://www.programyourremote.com/

depending on your alarm which it sounds like a viper model maybe? on my 02 you have to incorporate a factory alarm bypass module in order to be able to start the truck, they run about 100.00 bucks and have to be profssionally installed. The truck wont start because the computer isnt recieving the proper starting sequence due to the factory alarm