How do you replace egr valve in a 2005 dodge caravan

SOURCE: Replacing the EGR valve on a 2004 Dodge Caravan 3.3L engine

I repair mine last summer,
It is on the exast port, left.
You have a tube attach to it, going in the Head Cover.
Easy to change. it cost me $105.00CND at the dealer

Good Luck
Jonathan Lévesque

SOURCE: 2005 Dodge 1500 code p0404 EGR valve.

The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head ,

1. Remove electrical connector (5) at top of EGR valve solenoid.
2. Remove tube mounting bolt (1) at intake manifold.

1. Remove two bolts (4) connecting EGR tube (1) to valve assembly.
2. Remove gasket located between EGR tube flange and EGR valve assembly.
3. Remove two EGR valve mounting bolts (5).
4. Separate valve assembly (3) from engine.
5. Remove and discard metal gasket located between cylinder head and valve assembly.

1. Clean area at rear of left cylinder head where it joins base of EGR valve.
2. Clean EGR tube where it joins EGR valve.
3. Position new gasket between EGR valve and cylinder head.
4. Position EGR valve to cylinder head. Install and tighten two bolts (5). Refer to Torque Specifications.
5. Position new gasket between EGR tube flange and EGR valve assembly.
6. Position EGR tube (1) to side of EGR valve and into intake manifold.
   1. Install EGR tube flange bolt (1) at intake manifold. Tighten bolt. Refer to Torque Specifications.
   2. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final tightening of two EGR tube bolts (4). Refer to Torque Specifications

SOURCE: How do I change a EGR Valve on a 2005 Dodge Magnum STX w/3.5 engi

its a pain in the *** but it located on the right rear (pass. side) of the motor. it bolts to the cylinder head and runs up to the intake manifold

SOURCE: egr valve dodge durango

if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

ZJ Limited

• 17989 Answers
• Posted on Sep 07, 2009

SOURCE: egr valve location on dodge ram 2005 4.7

The EGR, or exhaust gas recirculation valve, takes inert exhaust gasses drawn from the exhaust system and reintroduces them into the combustion chamber through the intake manifold. This process lowers the peak combustion temperature and helps combat the formation of Nitrous Oxide (NOx) in the exhaust.

1. Separate the intake ducts from the air cleaner assembly by loosening the retaining clamps and pulling the ducts away from the housing.
   
2. Disconnect the vacuum line from the air cleaner assembly.
   
3. Remove the wing nut that secures the air cleaner housing lid to the base.
   
4. Remove both the air cleaner hosing lid and base.
   
5. Locate the EGR valve. Look at the front of intake manifold. The EGR valve will be bolted to the intake manifold just in front of the carburetor.