1990 Jeep Wrangler Logo

Related Topics:

Posted on Mar 09, 2011
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

My jeep is a 90 model wrangler 4 cyclinder standard my jeep will run a while then when you drive it down the road it acts like it is running out of gas when you turn the key on and off you hear a garling sound in the tank it has a new fuel pump in it what could be wrong with my jeep please....

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 165 Answers
  • Posted on May 24, 2011
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: May 22, 2011
Answers
165
Questions
0
Helped
34608
Points
451

Mybe the pumps pick-up isnt completly submerged.Check that

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

1995 jeep wrangler just stops running without warning.

A bad crank sensor will shut the jeep off suddenly, while driving down the road, then restart later and it repeats over and over until you replace it.
0helpful
1answer

Setting belt tension on 1993 jeep wrangler 6 cyclinder

Rule of thumb is that you should have just a bit less than one inch of deflection at the center of the longest run between pulleys. Check it again in a few days and re-adjust if necessary (usually not).
0helpful
2answers

Jeep wrangler 2.5. Motor idles up and down,

check the throttle possioning sensor on the throttle body that can cause alot of things
2helpful
1answer

I have a 1987 jeep wrangler and it will not shift into 4 wheel dr

The front axle connects 4wd by vacuum. check the vacuum hoses that run to the actuator. Pay close attention to the vacuum hoses running underneath the battery as battery acid can eat thru those hose easily. Good Luck.
0helpful
1answer

My car stalls

Check fuel filter . You have a mechanical pump & a carburetor on that model dont you?...Check fuel pressure (should be around 6-7 lbs) and check coil immediately after it shuts down...sometimes coils will act like that just before they go bad..
0helpful
1answer

Startin and runnin problems

Most common failure is crank sensor. Before running out and buying one, I strongly recommend that you do some further testing. Any decent manual has instructions for testing systems. Also: test both running and after it dies. (while running everything may check out as good) If you have spark when not running, check fuel filter as well!
0helpful
1answer

1999 Jeep wrangler runs rough

Check the gas, could be water in it or drive the car with a fuel pressure tester connected to it and watch to see if you lose pressure.
Normal pressure while driving is about 30 to 40 psi
0helpful
1answer

97 jeep wrangler 2.5 running lean

check fuel pressure and check exhaust for leaks. exhaust leaks caqn play with the o2 sensor readings
Not finding what you are looking for?

186 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...