Try ignition with key in and turn to number 2 and press fob button if the doors lock its worked, it f not you need to remove the battery negative and turn ignition on and lights and leave on for a few moments then turn all off again, then fit battery and do the first part again. hope this helps you.
SOURCE: removal of power steering pump on 1998 GMC Sierra 1500
you need a power steering pump puller the rest is simple any trouble let me know
SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem
your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps
Testimonial: "Very good information. THANKS!"
SOURCE: 2005 GMC Sierra 1500 - heater blows, but only cold air
Check coolant level. Check for heat at the heater hose going from water pump to heater core at firewall. Check to see that cable is moving coolant control valve from the closed to open position. Low mileage so it shouldn't be plugged heater core.
Testimonial: "You were absolutely correct. Low coolant level. Put in some 50/50 and we're nice and toasty now, but need to find out why coolant was so low. Thanks."
SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
SOURCE: I changed batteries in my 2003 GMC Sierra key fob
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
1 Put the vehicle in park, and turn the ignition to "On/Run" (don't crank the engine).
3 Press and hold the odometer trip stem again for three seconds. You will see the message "Remote Key Learning Active."
110 views
Usually answered in minutes!
×