-
Expert
60 Answers
- Posted on Mar 08, 2011
Re: How do I replace the turn signal multi-function...
SECTION 211-05: Steering Column Switches
1998 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 02/11/2000
Multifunction Switch
Removal
- Disconnect the battery ground cable (14301).
- Remove the ignition switch lock cylinder (11582).
- Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
- Insert a punch through the hole in the lower steering column shroud and push the ignition switch lock cylinder release tab while pulling out the ignition switch lock cylinder.
- Twist the tilt wheel handle and shank (3F609) and remove.
-
NOTE: Move gear selector to lowest position to access steering column opening cover.
Release the four clips and remove the steHow do I replace the turn signal multi-function - gj0847a.gifn opening cover.
- Remove the upper and lower steering column shrouds.
- Remove the three screws.
- Remove the lower steering column shroud.
Remove the upper steering column shroud.
- Remove the multi function switch.
- Remove the two screws.
- Disconnect the electrical connectors.
- Remove the multi function switch.
Installation
-
NOTE: When the battery (10655) is disconnected and reconnected, some abnormal drive symptoms may occur wHow do I replace the turn signal multi-function - gj0850a.gifhicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
To install, reverse the removal procedure.
×