Diagnostic trouble code P0089 - The ECM commands the Bosch high-pressure fuel pump to deliver a specific fuel rail pressure - that can vary up to 23,000 psi depending on load and speed. The actual pressure is monitored via the fuel rail pressure sensor. If the fuel rail pressure varies more than desired or if commanded fuel pump flow is 100mm3/second or less, DTC P0089 will set.
Corrective action includes measuring the fuel rail pressure using a Tech II scan tool, then compare that to commanded fuel rail pressure with the engine running at 2000 rpm. The difference must be less than 20 Mpa.
A blockage in the fuel tank or plugged fuel filter could cause this fault (excessive vacuum in fuel line). If there is less than 5 in Hg of vacuum when measured at the fuel pressure test port at 3000 rpm, the fuel pressure regulator could be defective, and may need to be replaced. The fuel pressure regulator (FPR) is a sub assembly located on the Bosch high-pressure fuel pump.
I have two references:
1)P0089 (The difference between actual and desired FRP is more than 20 MPa)
2)P0089 Fuel Pres Reg Perf.
See this article for more reference.
Does anyone has a solution
1996 chevy cavalier ets and engine light went on with startup and bucked and hesitated in low speed,is this a sensor? It ran fine before this. Just passed emissions and had an oil check and work done on it 3 months ago.
CODE 89 IS FUEL PRESSURE REGULATOR 1 PERFORMANCE.CODE 642 SENSOR REFERANCE VOLTAGE CIRCUIT "A" LOW.AND CODE 2004 IS ITAKE MANIFOLD RUNNER CONTROL STUCK OPEN.CK FOR BAD OR MISSING VACUUM LINES.IS IT STILL UNDER WARRANTY
2,939 views
Usually answered in minutes!
1996 cavalier check engine light & ets off when i start.bucks also
×