I have a problem I diskonnektid the airbag from the steringvell and before I diskonnektid the battery so I kut fix the interiollight svitsh and vhen I konektid the sistem agen the airbag ligt wont stopp blinking it blinks one long and *** short what does that mens .

Question edited to fix.
Question moved to model category.

If it is random, it may be a bad clock spring.

Why wont my airbag light go off? Go to see an auto-electrician if the airbag light still won't turn off. A worn-out clock spring inside your airbag's control module, a dead backup airbag battery, or a corroded terminal inside the airbag system are commonly the reasons why the airbag light is illuminating. In rare cases, your airbag may need to be serviced.
Dec 10, 2022

How to reset airbag light in six simple steps - Student Lesson

You can clear an airbag code with a scan tool. But if the fault is still there, the light will come back on. In that case, you need to read the code and fix the problem. It's usually a bad connection that shows up during a battery change. The fix is usually to power down the airbag system, disconnect and reconnect the connector that's triggering the code.

airbags are dangerous to work on for home mechanics.problem with airbags best to let dealership fix.if you can remove passenger airbag by disconnecting negative battery wait 20 minutes, beforeworking on the airbags. you have to remove glovecompartment to remove airbag mounting screws in the dash.

Yep, fuel pump time. it revs high because the ****** kicks down but not enough fuel to accel, not sure how the battery light plays in there though.

EITHER HORN BUTTON STUCK OR HORN RELAY STUCK.REPLACE HORN RELAY FIRST ITS CHEAPER SEE WHAT HAPPENS.IF HORN PAD IS THE PROBLEM.YOU MORE LIKELY HAVE TO REPLACE WHOLE AIRBAG UNIT IF HORN PAD BUILT INTO AIRBAG IN THE STEERING WHEEL..LET GARAGE FIX.DONT ATTEMPT TO FIX AIRBAGS IS DANGEROUS LET GARAGE FIX IF YOUR HORN PAD BUILT IN AIRBAG.

disconnect the battery. airbags won't deploy if there's no battery. and you dont have to worry about your airbags - the sensor to deploy them is in the front bumper of your car.

WELL BOTH REMOTES NEED NEW BATTERIES AND REPROGRAM.THE AIRBAGS IS A DEALERSHIP FIX.YOU HAVE FAULT IN THE SENSING DIAGNOSTIC CONTROL UNIT MICROPROCESSOR.THE ONLY THING YOU CAN DO IS CHECK AIRBAG FUSE.DEALERSHIP HAS TO USE DIAGNOSTIC EQUIPMENT TO FIX AIRBAG SYSTEM.

Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit

Take it into a Hyundai Dealership and have the SRSCM scanned for the specific trouble codes. They will tell you EXACTLY where the problem is and what's needed to fix it. NOW, having written that, if you want to try 'CLEARING' the airbag light to see if it comes back 'ON', disconnect the battery cables (+) and (-) from the battery and touch them together for 10 seconds (this is with the ignition key in the 'RUN' position). Reconnect the cables to the battery to see if the Airbag light comes back on or stays on. If it does, then have it diagnosed by a qualified technician.

This is either a problem with one or both of your airbags or the airbag connector located at the back of the glovebox has been disconnected for some reason. (ie. to prevent airbag opening when installing baby seat) (1999 miata does not have a baby seat airbag disabling sensor).

You should get your car inspected at your local mazda service to check if this is a wiring (plug disconnected) issue or one of your airbags is malfunctioning and needs to be replaced.

Flashing airbag light could indicate that either one of the airbags or both have a problem. Disconnecting the passenger's airbag has the same effect.

Warning! Do NOT attempt to do any kind of airbag/airbag wiring related repair yourself. Airbag problems should be addressed ONLY by certified technicians at your local Mazda service. (Airbag fixing requires for example that the car battery is disconnected, you MUST NOT attempt anything with the car battery connected).


Hope this helps.