I have a1997 nissan 4x4 pickup with a ka24e bad engine, I found a ka24e engine out of a 1995 4x4 pickup. To get the engine to hook up to the 97 it looks like Iam gong to hve to change intake and distributer. when comparing the engines I noticed a big difference with the distributer,the position of the no.1 firing pin is in the top left position on the distibuter cap and the 95 is on the lower right hand position on the cap. Will these two engines swap out?

Hi Eddie,Here's a link to a Nissan part site,the starter relay is 25224G.If you look at the truck picture,it has letter's,find letter G AND THAT'S WHERE THE STARTER RELAY IS,BY THE WAY,i HAVE A MINT 85 nISSAN 720 4X4,HERE'S A VIDEO OF IT,TAKE CARE. Parts found for 1996 Nissan Hardbody Pickup 1995 1997 Body Electrical Relay CHECK MINE OUT. 85 Nissan 720 4x4 2 4 Weber conversion

they are pretty much all the same line up your 2 camshaft marks with your crankshaft mark they should all facing the same direction ,if you look on ebay I will bet your problem is solved there , good luck

No oil treatment is needed or recommended for use in an engine. The present day engine oils are formulated with various modifiers to provide proper lubrication, viscosity and cleaning to your engines internal parts. Using ANY additive could upset the formulations by adding chemicals which aren't compatible with the oil you are using. It's much better to just select a good oil and stick with it.

Also here is a site , which will tell you , depending on where you live , what oil is recommended for a Nissan Pickup .
http://www.synthetic-motor-oil-change-and-filters.com/recommended-oil/NISSAN/1997/PICKUP/2.4L/KA24E/
I myself have been using Pennzoil in my truck for 7 years and I change the oil every 3750 miles . If you do not want to follow my advice , bring your Nissan truck to a dealer and ask them . The oil most dealers use is oil that comes in a 55 gallon barrel and is used in all vehicles .
Good luck

Sorry but what are you asking?? more info please.

It is either a Z24i, or a KA24E. You should find the identification number on the left side of the block at the rear. It should say what size it is.

Go to:
http://www.240edge.com/manuals/s13-ka24e.html
and download the "zip file". Even though it's a older 240sx it IS the exact engine in your truck....and FREE!!!

:-)

pump running half speed? check for bad ground and yes you need an OBD 1 scanner,need more help get back to me as i strive to be the best. Please rate my fix? Thanks Ray

My 97 pickup has to be in neutral. Push clutch in push down on 4x4 handle and then shift back or forward on lever. Plus engaging the lockout on hubs.

this is an interference motor, if cranked the valves will come into contact with the piston and cause major damage. Its very possible that valves may have bent(worst case). Have the belt replaced and engine pressure tested. Hopefully its not the worst case.

check the fuel injectors