Dose this vechicle have a cabin air filter? If so,were is it located.

SOURCE: LOCATE AC CABIN AIR FILTER

no cabin filter on 2003 crown vic cabin filter is under pass cowl trim

SOURCE: Cabin Air Filter Location

Empty glove box, remove axcess panel and the open the axcess door, two (2) filters inside,

SOURCE: Engine Air Filter

The engine air filter is located in the box behind the battery. This box should have 4 metal clips that pop off and you and pick up the top of the box and underneath is the filter.

SOURCE: cabin filter element location

Filter is located behind the glove box. All you need is a screwdriver to replace.

1. Open the glove box and empty to take the weight off the box.

2. On the right side there is a plastic hinge like device held on by one Phillips head screw. If you have trouble removing with a Phillips screwdriver you can remove with a narrow flat head screwdriver. Remove the screw and slide hinge off the mount.

3. To drop the glove box press the sides slightly inwards while 'forcing' it open beyond it's normal stopping point. Careful as when it releases it will fall wide open and may even fall from its hinged area. Set it aside.

4. Behind the glove box there is probably some fiberous material inserted to prevent noise like squeaking when it rubs. It is sticky on one side to hold it in place. Just remove and place out of the way.

5. Behind the fiberous material there'll be a cover which kinda looks like a grille. Mine was white and it is in the center of the opening. Remove it by releasing the clips at the left or right. It comes right out.

6. When the cover comes off slide the filter out and replace it. The filter lays flat and just slides in and out easily. However, if it has been some time since you replaced be prepared for a lot of debris on top of the filter such as leaves, grass or other general type of debris that has been sucked into the filter. It also may be the source of any bad odors that you smell through the air conditioning system.

7. Reverse the process. Replace the cover and push the glove box lid back into place. When you replace the glove box be careful to make sure the hinge you initiallly removed the screw from is not left behind the glove box or you will have to remove again to get it out. Replace the screw and do not over tighten as it screws into plastic and then your done.

SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)

IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE