Dont need to be bleed . if that was the case the clutch would not release and stay on all the time
sounds like the clutch disc is wearing out and beginning to slip in the lower gears (they have higher toqure in these gears to get the truck to start moving ) which means they put a hevey load the disc and presure plate assembly .
Testimonial: "thank you! I thought that. I wanted to make sure before I spent the money Ilike getting that expertise.thank's again"
The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft. It knows which gear you're in because it commanded the transmission to shift into that gear. So, with the input speed, the gear selection, and the output speed, the computer can calculate how efficiently the transmission is working. If the speed is off, it knows that something is slipping inside the transmission. It can then try to boost the fluid pressure to compensate. If that doesn't work, it sets a different trouble code.
The P0717 code means that the computer isn't getting any signal from the sensor. Either the sensor is dead or there's a circuit issue (bad wiring, etc).
212 views
Usually answered in minutes!
×