Steering wheel wont go up or down or in and out

https://www.youtube.com/watch?v=d9dEOtFgKDc
Method 1 Unlocking Your Steering Wheel

1. Insert the key into the ignition. ...
2. Turn the key gently. ...
3. Apply pressure to the steering wheel. ...
4. Do not shake or rock the wheel. ...
5. Pull the key out slightly before turning it. ...
6. Turn the wheel and the key at once to unlock it.

https://www.wikihow.com/Fix-a-Locked-Steering-Wheel

Cause!
One of the most common reasons why a steering wheel won't lock right is that the detent is broken or worn down. If you don't know what the word detent means, then don't worry. The detent is basically "the catch" part that makes sure that your steering wheel locks into place.
https://carroar.com/steering-wheel-wont-lock/

wiggle steering wheel up and down sometimes the steering lock tab jams and wont permit key to turn ====if key worn down will not let ignition cylinder turn other is bad ignition cylinder

Damage connection of wires inside steering wheel or column

Telescopic steering wheel stopped moving - MBWorld.org Forums

mbworld.org/.../225749-telescopic-steering-wheel-stopped-moving.html

Jan 9, 2008 - Telescopic steering wheel stopped moving ... If it won't move at all, and you don't even hear a motor, it could be a fuse; check your fuse diagram ... Steering wheel adjustment motor gone bad?
Jan 28, 2008
HOW TO: Fix power steering column that will not move up and ...
Jul 12, 2007
More results from mbworld.org

Fixing the Power Steering Wheel of a Lexus LS400 - YouTube

? 2:15
https://www.youtube.com/watch?v=NP8YmnGRXWU
Jan 4, 2012 - Uploaded by AutoTech USA
If your power steering wheel is no longer working; moving up and down, back and forth, and when you attempt ...

telescopic and tilt steering not working - Cadillac Forums

It should move in and out (it pulls out and pushes in) It doesn't move up and down. Reply back if it won't do either.

Sounds like broke wires in the steering collom
usually happens if the steering wheel gets moved up and down allot

This is usually because of serious proload. Happens easily, with power assist....you shut down, now too hard to release.

So, you get the key ready and apply normal pressure to turn key.... then ARM STRONG the steering wheel, one way and the other. Somewhere in there, the key system should release.

Try pressing the key down little bit while you are trying to turn it towards ignition, at the same time slowly turning the steering wheel clockwise and counter clockwise ( it's locked but it still moves a little bit), it should release the steering wheel lock. hope it helps
p.s please rate the answer if you found it helpful, i need it for my ratings, thanks!

It has a nut on center, to get there, You have to remove horn depressing mechanism, it is attached to wheel, with screws holes 2 or more behind steering opposite side to You on the dash side of the steering wheel, the par You can't see, remove both Philips screws with spring mechanism, the inside of the steering is made of sheet metal, on the center of the steering You will see a big nut with a washer, make sure steering is locked *** the nut with clock, if free place remains after, or You note that steering wheel is secured and nut wont turn, look below, follow column down, than You will see a flex cross on steering axle, if cross OK, steering wheel OK and problem remains, Look at steering box free play if, problem? Take to a shop

you have a steering linkage broken possibly the pitman arm. it attaches to the steering box