SOURCE: trunk releasse
The trunk release should be located in the center console around the shifter by the window buttons. That is where it is located in my brothers '97 Mercedes C280...hope this helps, good luck
SOURCE: camshaft position sensor location
At the right rear of the engine under the intake manifold and to the left of the oil filter. You will probably need to go under the car to spot it, it's the sensor with a three-wire connector arranged vertically. But you can take it out from above. It's held in with a single bolt with an eight MM head located just above the sensor. Un-clip and remove the electrical connector. Unscrew the bolt with a socket wrench & extension bar. Wiggle and pull the sensor out.
here is a picture.
SOURCE: p0014 engine code
THE CAM SHAFT ACTUATOR IS LOCATED IN THE CYLINDER HEAD ON THE FRONT RIGHT HAND SIDE JUST ABOVE THE POWER STEERING PUMP. AFTER YOU REMOVE THE ACTUATOR CHECK TO SEE IF ANY OF THE SCREENS ARE DAMAGED OR MISSING. IF SO REPLACE THE ACTUATOR. ALSO CHECK THE CRANKSHAFT END PLAY. IT SHOULD BE BETWEEN 0.0044" - 0.0153". if excessive crankshaft end play is causing this concern, it will be obviously out of specification by as much as.050" or more when a pry bar is used to move the crankshaft back and forth. IF THIS IS THE CASE AN ENGINE REPLACEMENT IS RECOMMENDED DUE TO THE AMOUNT OF DEBRIS IN THE ENGINE. IF NO EXCESSIVE CRANKSHAFT MOVEMENT NOTICED REPLACE THE CAM ACTUATOR. IT WILL ALSO BE NECESSARY TO DO AN OIL CHANGE.
SOURCE: Where is the camshaft position sensor located in a 2001 VW Passat
when you are looking at the engine pull off the plastic cover on top then the front cover that covers you timing belt there is a wire harness tha goes right to it in the left upper coner two ten mil bolts and it comes off careful not to drop bolts down in belt that could be bad. it is that easy
SOURCE: ''B'' Camshaft Position - Timing Over-Retarded Bank 1
When dealing with the camshaft positioning sensor, this should be done by a certified mechanic.You can purchase a Chilton's repair manual for this auto, but I don't believe it will be of much help. I had the same problem on a newer ford, and wasn't equipped to do this job.Try giving the Mercedes dealer a call, and talk to one of there mechanics. I hope I have been some help to you.
Sincerely, shastalaker7
P0010....'A' Camshaft Position Actuator Circuit (Bank 1)
P0011....'A' Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)
P0012....'A' Camshaft Position - Timing Over-Retarded (Bank 1)
P0013....'B' Camshaft Position - Actuator Circuit (Bank 1)
P0014....'B' Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)
P0015....'B' Camshaft Position -Timing Over-Retarded (Bank 1)
P0020....'A' Camshaft Position Actuator Circuit (Bank 2)
P0021....'A' Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)
P0022....'A' Camshaft Position - Timing Over-Retarded (Bank 2)
P0023....'B' Camshaft Position - Actuator Circuit (Bank 2)
P0024....'B' Camshaft Position - Timing Over-Advanced or System Performance (Bank 2)
P0025....'B' Camshaft Position - Timing Over-Retarded (Bank 2)
I think your sensors are pattern parts and the readings /resistances are not the same as the original parts ,try some bosch units is my first suggestion ,
892 views
Usually answered in minutes!
×