1996 Chrysler Sebring Logo

Related Topics:

Posted on Mar 30, 2017

96 Sebring JXi, 2.5 L V6. The problem is an intermittant "no crank" upon turning the key to start. All internal lights and dash light up. Headlights turn on. This problem "seems" to manifest itself after the car has been started and driven a few times for about 30 minutes. Occasionally I can get the car to start with a jump after it has cooled off for at least four hours. Measured full battery voltage across the starter relay. Starter relay appears to be good. Am considering checking the battery temperature sensor, but I'm not sure how to accomplish that. Also curious how to check the Park/Neutral lockout switch. Thank you for any help. Mike K.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Sep 16, 2008

SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Ad

Anonymous

  • 1 Answer
  • Posted on Dec 12, 2008

SOURCE: 2001 pontiac sunfire wont start

I have had the exact same problem. There is an ignition lock that probably went off. There is a fuse box under the hood. The fuse that says ignition on it pull it out and put it back in. This should reset the ignition lock. Its a safety feature because the car thinks that someone was trying to tamper with it.

Anonymous

  • 158 Answers
  • Posted on Apr 03, 2009

SOURCE: 2000 sebring transmission pan torque spec

10 ft lbs no real patterm needed

kirtec auto

  • 1348 Answers
  • Posted on Jul 22, 2009

SOURCE: Engine won't start. Dash lights flash rapidly when key turned.

the battery says 12 volts but may be dropping to 4 or 5 under a load...i would suggest jumpstarting the car and see what happens.the battery should read in the high 12 volts and not less than 9.5 under cranking. the dash lights go out on your car when starting,and the alarm will go off ,and disable the ignition if the voltage is too low in cranking the car because the computer will shut it down and activate the anti theft.....check your battery posts are tight. best of luck

Anonymous

  • 466 Answers
  • Posted on Aug 03, 2009

SOURCE: Won't crank. Have power to starter. Advance said

CHECK THAT THIS IS THE SWITCH IS IN THE CURRENT TRANSMISSION GIVES YOU THAT WHY GO TO CURRENT MOTOR STARTER

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

My 2002 chrysler sebring 2.4L will not start turn key and hear no clicking noise nothing at all, lights and horn work , when i jumped the battery it did nothing no clicking. what should i try next?

Check if you have power at the starter from the ignition key
Try give direct power to the starter, if still not starts, you have a bad starter
1helpful
2answers

Engine will not start no spark jxi v6 2-5 litre

check the ignition control module in the distributor or the crank position sensor
0helpful
1answer

1999 chrysler sebring low oil pressure at idle

It may be the oil pump. If the gauge is going up when the rpms increase it's probably not the gauge or pressure switch. If the computer senses the oil pressure is low it will shut the vehicle off to try to save it's self from catastrophic failure. Also it may start cranking longer before starting. Thats it building oil pressure before the computer will let it start. Make sure oil is full, clean & thick.
0helpful
2answers

1997 chrysler sebring jxi no start

Do head lights stay on (bright) while trying to crank starter? If not, starter motor isn't getting enough current, OR engine is locked. Is there current getting through the solenoid to starter motor? Check the ground connection between the engine and chassis as well as battery and chassis.
0helpful
1answer

I have a 02 pontiac grand am. Its a v6 ram air. when I put the key in and turn to "on" all the dash lights and the headlights come on. but when I turn the key over to start it all dash lights and...

You need to have a good battery in it. There are to many computer controlled opponents. Put a new or known good battery in it and try it. If it doesn't start then check for fire at the plugs and fuel pressure at the fuel rail.
0helpful
2answers

98 Sebring JXI turn signals work right/left and

Change the flasher which is located up by fuse block under dash
5helpful
1answer

I have a 96 Olds Cutlass Supreme that intermittently won't start

If the lights on the dash all come on but the engine wont turn over it could be a problem with the VAT security system. Your key has a little chip on it between the teeth and the handle. This is a common problem with GMs', often just replacing the key is necessary but sometimes the VAT module needs to be replaced.
0helpful
1answer

1998 Chrysler Sebring JXI Convertible Blower Motor Not Working

Sounds like it in the switch or the electrical plug at the switch.The electrical plug could be burnt and need repairing or replacing. Need to remove the dash fascia, Careful not to damage clips. If the cover has no visible screws or bolts, then it clips into place. Unbolt heater controls and pull contol forward. Not a fun job but with patience you should be ok.
Not finding what you are looking for?

72 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...