Question about 2010 Subaru Tribeca

1 Answer

What is the toggle switch on the steering colum on my suberu

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Subaru Master
  • 4,387 Answers

Usually it's a kill switch fr an add on alarm system.

Posted on Mar 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The alarm went off and cant get it to shut off where is it located at so i can unplug it


usually the valet switch is located near the driver side under d steering colum,, 1 small botton ,, if d alarm wennt off,. use the car key.open d door,use d key to ignition on position.. den push d switch 1 time...some switich are toggle type just switch it d other sde. until alarm went off...

Sep 11, 2013 | 1995 Jeep Grand Cherokee

1 Answer

Can I bypass ignition switch on steering colum with a toggle on a 1997 camaro if so how?


From toggle switch straight to starter you still need key so steering wheel won't lock

Sep 04, 2013 | Cars & Trucks

1 Answer

Where is the 1997 buick lesabre ignition switch located


its located at the base of the steering colume by the firewall on top of the colume.there is a rod that comes from the top of the steering colume down to the switch.when you turn the key it moves the rod which moves the switch internally allowing the car to start.

Nov 09, 2011 | 1998 Buick LeSabre

1 Answer

Burning smell and small amount of smoke from the steering column


sounds like you have a short in the steering colume causing the smell and the smoke.is there something that is not working that was before this happened that is controlled by the switches on the colume.this can indicate what switch is bad and causing the problem.it will have to be checked out to know what item in the colume is the problem.

Sep 04, 2011 | 1997 Lincoln Continental

1 Answer

What could cause brake lights to work every now and then


I would check your brake light swich located under dash just fallow your brake pedle with a test light see if you have power going to it slitely press brake pedle see if other side of switch has power (key on car not running) if not try ajusting it by pulling on it or unscewing it if all checks out ok replace turn signal switch disconnect battery remove center part of steerring remove center bolt with steerring puller pull steering wheel with locking plate puller pull locking plate remove turn signal handle emergency button three scews holding turn signal under dash fallow steering colum disconect wires on right side (passenger side) tape a long wire to end of connector pull turn signal without pulling tape wire all the way out so you can tape it to new turn signal wire connector to be able to pull wires back down steerring colume (you might have to losen steerring colume and bracket two scews under dash four on steering colume)

Jun 27, 2011 | 1998 Dodge Ram 3500 2WD

2 Answers

Where is the ignition switch in an 1989 chevy S-10


Remove lower dash panel, under steering wheel, there will be a bracket that holds steering wheel, remove both 15mm nut's that point up, not the 13mm bolt's the screw into the colum , steering wheel will come down enough where you will see the ignition switch on the top side of the colum, the switch will be screw to the colum with the head light dimer switch.

Jul 15, 2010 | 1989 Chevrolet S-10 Blazer

1 Answer

1991 buick regal, i need instructions on how to replace a ignition switch


key switch,remove center cap and pull steering wheel off with wheel puller.disconect horn,blinkers assembly.push pin remove ignition. ignition switch, remove panel under dash un bolt steering colum lower to seat un screw ignition from top steering colum un hook rod,un plug harnees put new one on put back together

Feb 02, 2010 | Buick Regal Cars & Trucks

1 Answer

Turn signals dont work at all hazards too


if the fuse is good then the multifunction switch is bad. this is the switch in the steering colum. this switch comes with the signal arm that comes out the side of steering colum as a complete assembley. the top and bottom covers of the steering colum must be removed to change switch.

Feb 14, 2009 | 1997 Ford Taurus

1 Answer

Steering colum vacuum lines


they shoud both go to the vacuum switch on top of the column one is the vac source and the other goes to the release

Oct 15, 2008 | 1996 Lincoln Town Car

Not finding what you are looking for?
2010 Subaru Tribeca Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...