STEP BY STEP INSTRUCTION First, any time you work around the steeringcolumn you it is a must to disable the air bag system you will do this my disconnectingthe battery. After you disconnect the battery wait at least 5 minutes before proceeding.
1. Ifyou have tilt remove the tilt actuator arm by firmly pulling straight out.
2. Removethe upper and lower trim covers.
3. Removethe wire harness assembly from the wire harness strap.
4. Disconnect the turn signal andmultifunction switch assembly connector from the SIR system coil connector.This is alongside the steering column there is an 8mm bolt in the center of theconnector that must be removed to disconnect the connector halves.
5. Slide the 2 connectors of the turnsignal and multifunction switch assembly out of the bulkhead connector. With a smallscrewdriver slightly pry between the connectors to release them.
6. Removethe 2 pan head tapping screws and from the turn signal and multifunction switchassembly.
7. Removethe turn signal and multifunction switch assembly from the steering column tilthead assembly.
INSTALLATION PROCEDURE
1. Installthe turn signal and multifunction switch assembly onto the steering column tilthead assembly.
2. Screwthe 2 pan head tapping screws and into the turn signal and multifunctionassembly.3. Slidethe 2 connectors of the turn signal and multifunction switch assembly into thebulkhead connector.
4. Connectthe turn signal and multifunction switch assembly connector to the SIR coilconnector.
5. Installthe wire harness assembly (1) into the wire harness strap (2).
6. Installthe upper and lower trim covers.
7. Installtilt actuator arm.
8. Reconnectthe battery.
701 views
Usually answered in minutes!
×