SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited
do you mean they are sticking?
SOURCE: door closed but door ajar comes on
There is a switch or sensor on the door frame either on the hinch side or on the latch side. Try to activate it with the the car on. With the door open, the door open light should light on, if it is a mechanical switch, push it in, if a sensor, touch it with a steel object, the light should turn off. This means the door switch is working ok. Now try the same again but this time push the switch slowly until the door ajar warning light turns on. This means that the switch works ok. Now, close the door from outside and check that there is no gap betwwen the body and the door line all over the perimeter of it. If there is a gap mainly at the latch side or at the hinch side, it can be your problem. If so, let me know so I can show you how to adjust the door to eliminate the gap.
If there is no gaps, your door switch is to low (too far in), let me know so I can show you how to adjust it.
SOURCE: My 2001 Chrysler Town & Country passenger sliding door won't open
your door panel can come off and you can access internal door locking mechanism from inside car first inspect to see all rods are hooked into plastic sleeves then make sure lock is disengaged by pulling rod towards rear of van it should then be able to be opened easily if not your locking mechanism is frozen inside of door between a pillar and door it will have to be pushed to open from inside of door panel once you do that door will open if you cant make lock work manually once this is done replace locking mechanism or rods accordingly.
SOURCE: The power lock (driver's side sliding door) on our
Take a look at end of door where latch is & post where the 2 meet when closed. Look for round metal button/contacts, about 1/2" in diameter. If you look close, they should line up to make contact with each other when door is closed. Take some fine steel wool (preferred) or fine sandpaper and scuff them up until you see metal is clean on both surfaces. Now try it, and let me know what happens.
SOURCE: Power door lock inoperable on passenger sliding door only
Not sure if they are same on 2006 but there should be a couple of small rounded metal contacts, or similar, on door that meet with door post to complete the connection. When you find them, clean them off with a little fine steel wool or SOS pad, minus the soap, and see if that doesn't cure it.
68 views
Usually answered in minutes!
×