Gas display is burnt out - 2000 Toyota Camry

Question 1

0helpful

1answer

Thank you for your response bill boyd i suspect egr the tubes at the block and intake clogged could this have caused burned hole in #2 piston 1996 sentra 1.6 ?

It is possible as it will alter the air/fuel ratio. The EGR valve is designed to re-admit exhaust gas into the manifold so as to slow down combustion by the introduction of already burnt gas or partially burnt gas to obtain the correct exhaust mixture for pollution requirements. I would still check the tops of the pistons for the indents as it will affect all the pistons although the weakest piston failed.

Jul 22, 2014 • Cars & Trucks

0helpful

2answers

How could I tell if my 3406E engine has a burnt valve

Hold a piece of paper to cover exhaust it should move in and out like it does when you hold it against your mouth and breath if it stays out steady you have a burnt valve or just hold foot on the brake and apply a little braking force and press gas like power braking if it stumbles it's probably a burnt valve

Jul 15, 2014 • Cars & Trucks

0helpful

1answer

Number 1 cellender is running to ritch and miss fire ,how do I fix it , how to fix it

Pull the plug in cylinder #1 and inspect it for corrosion, burnt or rich with gas. If corrosion or burnt replace plugs if wet with gas and the plug is in good condition replace distributor cap and rotor, if this model has coil packs replace the coil pack that covers cylinder #1 it may also cover another cylinder as we'll some of the earlier models had two cylinders per coil. Hope this helps

Oct 20, 2013 • 2000 Chevrolet Cavalier

0helpful

1answer

Automatic transmission wont shift unless foot right off gas peddle

There are none

The transmission is burnt-- you said it

Has to come out & be rebuild or a reman installed

You new that-- right?

Sep 01, 2013 • Chevrolet Monte Carlo Cars & Trucks

2helpful

1answer

It revs up when you give it gas

Transmission is probaly slipping, Check that the fluid is up in it, End all so if it smells burnt, If there is a burnt smell to it or the fluid is dark in colour not red, Like stay a darkish brown colour, Your transmission will have to be (Rebuilt)

Oct 29, 2012 • 1999 Chevrolet Tahoe

0helpful

1answer

Speedometer, gas gauge not working

Hello,

The problem you are experiencing is as a result of the fact that the fuse that control the speedometer and the gas gauge is burnt out,the solution is to;
Replace the burnt fuse which is found in the fuse box under the dash,
Problem solved.

Thanks for using fixya.

Dec 14, 2010 • 1997 Plymouth Voyager

0helpful

1answer

Car runs fine but gas millage dropped to about 10 mpg this week

might have burnt piston rings. check if u are burning oil, if not then thats ur problem. (piston rings)

Jun 02, 2010 • 1995 Toyota Camry

0helpful

1answer

My truck didnt pass smog they said it was a firing issue and some gas isnt getting burnt..is it the spark plugs? are they out of order?

If your plugs weren't wired right you would have trouble with missing, rough idle if it would start and run. Some gas not getting burnt suggests that a tune up may be in order. New plugs, wires, cap and rotor. It would be a good idea to have the throttle body checked out, 16 years of gas flow will wear it and maybe its putting out a little too much gas. Going one hotter on your plugs could also help get rid of that unburnt gas. Make sure there are no codes that would affect gas consumption, if there is fix them first. Hope this helps.

Sep 24, 2009 • 1993 GMC Sierra

1helpful

1answer

Fixed ac problem now smell gas inside vehicle

burnt or unburnt gas? if burnt gas smell look for bad manifold or manifold to pipe (donut) gasket.
if unburnt smell look for gas line leaks

Jul 28, 2009 • 1998 Ford Windstar

0helpful

2answers

Graphic Display Module

Pull the display and check for a burnt out illumination bulb, I have not seen this cause any AC smell.

Sep 05, 2008 • 1997 Jeep Grand Cherokee

Question 2

Anonymous

Expert 252 Answers
Posted on Feb 28, 2011

Anonymous

Expert

Joined: Feb 19, 2011

Answers

252

Questions

6

Helped

101366

Points

721

Need more information......Do you mean the fuel gauge doesnt work ?...If it is actually burnt out the instrument cluster is burnt in one spot.....this is the first step in the process of complete gauge failure...it is normally the first to go...sometimes it will be the only gauge to not work....
Although if the gauge isnt working the in tank float is stuck and or fuel sending unit has failed.First make sure it has fuel in it (put in 2 gallons)...You dont want to put very much in because if it is the float you will have to remove tank.
It is best to replace the complete fuel sending unit rather than just the float...mainly because one can make the other go bad...also for some models you cant purchase the float only.........It would save you money to have the PCM scanned for fuel delivery system.this will tell you where fault is.
If you can visually see a burn place at the gauge the cluster has failed.

Related Topics:

Trustworthy Expert Solutions

Gas display is burnt out - 2000 Toyota Camry

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Thank you for your response bill boyd i suspect egr the tubes at the block and intake clogged could this have caused burned hole in #2 piston 1996 sentra 1.6 ?

How could I tell if my 3406E engine has a burnt valve

Number 1 cellender is running to ritch and miss fire ,how do I fix it , how to fix it

Automatic transmission wont shift unless foot right off gas peddle

It revs up when you give it gas

Speedometer, gas gauge not working

Car runs fine but gas millage dropped to about 10 mpg this week

My truck didnt pass smog they said it was a firing issue and some gas isnt getting burnt..is it the spark plugs? are they out of order?

Fixed ac problem now smell gas inside vehicle

Graphic Display Module

Not finding what you are looking for?

2000 Camry

Thank you for your response bill boyd i suspect egr the tubes at the block and intake clogged could this have caused burned hole in #2 piston 1996 sentra 1.6 ?

Ask a Question

Check Out the Latest Top Trucks Report!

Top Toyota Experts

ZJ Limited

Ronny Bennett Sr.

Thomas Perkins

Are you a Toyota Expert? Answer questions, earn points and help others

Manuals & User Guides

. 2000 Camry Manual

Related Topics:

Trustworthy Expert Solutions

Gas display is burnt out - 2000 Toyota Camry

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Thank you for your response bill boyd i suspect egr the tubes at the block and intake clogged could this have caused burned hole in #2 piston 1996 sentra 1.6 ?

How could I tell if my 3406E engine has a burnt valve

Number 1 cellender is running to ritch and miss fire ,how do I fix it , how to fix it

Automatic transmission wont shift unless foot right off gas peddle

It revs up when you give it gas

Speedometer, gas gauge not working

Car runs fine but gas millage dropped to about 10 mpg this week

My truck didnt pass smog they said it was a firing issue and some gas isnt getting burnt..is it the spark plugs? are they out of order?

Fixed ac problem now smell gas inside vehicle

Graphic Display Module

Not finding what you are looking for?

2000 Camry

Thank you for your response bill boyd i suspect egr the tubes at the block and intake clogged could this have caused burned hole in #2 piston 1996 sentra 1.6 ?

Related Topics

Ask a Question

Popular Questions

How to fix diagnostic code p0442

Electric front seat stuck

I have relay saying :mg clt what is that mean?

Starter making whining noise

VSC Trac off lights on dashboard

Check Out the Latest Top Trucks Report!

Top Toyota Experts

ZJ Limited

Ronny Bennett Sr.

Thomas Perkins

Are you a Toyota Expert? Answer questions, earn points and help others

Manuals & User Guides

. 2000 Camry Manual