NEED A DIAGRAM FOR THE ROUTING OF A SERPENTINE BELT ON A 2001 PONTIAC BANNEVILLE SSEI SUPERCHARGED

Question edited for clarity.
Question moved to model category

https://www.google.com/search?q=2001+A8+Quattro+4.2.+serpentine+belt+diagram

there should be a decal under the hood somewhere that shows the belt routing. if its gone you can probably go to the library and find a book of your car that will show the routing and you can either draw a picture or take a photo of it.

Serpentine drive belt routing-GM “C and H” Bodies 3.8L (VIN 1) engine

Here ya go!

Dayco Serpentine Belt Routing Guide http://www.daycoproducts.com/daycoweb.nsf/Serp%20Routing%20Guide.pdf

Dayco Serpentine Belt Routing Guide Illustrations
http://www.daycoproducts.com/daycoweb.nsf/Serp%20Rout%20Guide%20Illus.pdf

I think it's illustration 5-20

Go to this link:

http://www.mvreader.com/multiview/dayco/index.php?bgInterchange=1&l=n

Enter your vehicle information. Then click on Belt Routing Diagram, It will pull up a picture of the diagram.

Fig. Fig. 8: You can use a box-end wrench on the pulley nut to rotate the tensioner ...


Fig. Fig. 9: ... then remove the belt from the pulleys


Fig. Fig. 10: Serpentine drive belt routing and removal - 3.8L (VIN L) engine shown, VIN C similar


Fig. Fig. 11: Make sure to note the drive belt routing prior to removing it - 3.8L (VIN K) engine shown


Fig. Fig. 12: Drive belt removal on a 1992-95 supercharged engine
To install:
Be sure the belt is aligned into the proper grooves of the accessory drive pulleys.

1. Lift the tensioner, and install the belt onto pulleys. Make sure the belt is routed properly.

Fig. Fig. 13: Many vehicles have a label you can check to be sure the belt is installed and routed correctly

1. For 1996-99 vehicles, raise and safely support the vehicle. Install the engine mounting bracket lower spacer, stud and nut.
2. For 1996-99 supercharged engines, perform the following:
   1. Attach the connector to the crank sensor.
   2. Install the right-hand splash shield, then carefully lower the vehicle.
   
   
3. Install the belt guard or reservoir.
4. Connect the negative battery cable.

The diagram you requested is below:

10171018 <-part # for a belt routing label.
there should already be a belt routing label under the hood or on your core support with a picture :}

This is the one for the supercharger.

these motors have two carrier pulleys and oone tensioner. lookinjg at the motor from the rightside of car the belt goes as follaws: crank pully to super charger from the left. the right side goes up to the lower carrier which will have the flat of the belt riding on it. from there the belt routes to the upper carrier
[ loop it over so the grooves ride
] and then under the tensioner any questions contact [email protected]