Hello lucasgraves,
If you have a 4.0 the crank position sensor is mounted to the transmission bell housing at the left rear side of the engine block. Left is drivers side.
If you have a 4.7 the crank position sensor is mounted into the engine block above the starter.
If you have a 2.5 the crank position sensor is mounted to the transmission bell housing at the left rear side of the engine block.
If you have a 3.7 the crank position sensor is mounted into the right rear side of the engine block.
Regards,
netvan
Take a look on the drivers side of the bellhousing, you didnt say what size motor you have. You might have to look from under the car
In the transmission bell housing, passenger side at about 11o'clock if looking from the front.
SOURCE: how to change crankshaft sensor jeep YJ
Raise the front of your Jeep with a jack and position a set
of jack stands under the front axle to support it. Lower the jack,
allowing the Jeep to rest solidly on the jack stands.
674 views
Usually answered in minutes!
×