Grab one at the junk yard, cheap. If you don't have turn signal lights in your mirrors, grab a pair off an Envoy. Plug and play right into the master door switch. The heated mirrors work with the defrost button for the rear.
Fit a new unit, The part that has snapped is probably a tiny leg of plastic that is irreplaceable and not repaireable.
SOURCE: replacing passenger side miror
need to replace the exterior mirror on the passenger side. How do I remove the mirror from the out side. all the wiring is out Just need advice on how to take of the existing mirrow and replace it with a new one. Does the inside panel need to come off, how many bolts are needed for removal.
Felix.
SOURCE: Need to replace the broken outside right passenger mirror I have replacement
To repace the COMPLETE MIRROR UNIT, the inside door trim must be removed. Hope this helps
SOURCE: take apart passenger side mirror chevrolet 2008 tahoe
get some eye protection
then pry the pieces out
also try pooring hot water on it to soften the glue
SOURCE: replacing spare tire winch 2004 chev trailblazer
I have a '02 TrailBlazer and I had the same problem. When I got a flat and went to change the tire on the side of the road I was not able to get the tire off the winch. Luckly, I have AAA and the driver knew the trick to getting the tire free. The process involved lowering the tire as far as it would go and then kicking it. Wind back up and repeat until the winch free's itself.
When I took the car into the shop to get the tire fixed and the have the spare put back on the car, they were not able to get the winch free enough to put the tire back on. They said that is is a common problem with this mechanism and suggested replacing the winch system (estmated parts and labor $215). From what I can tell the winch accumulates rust up in the cable and locks up.
SOURCE: Im trying to replace the passenger mirror, need to
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Once the panel is off, you will see two or three bolts securing the mirror assembly onto the door
Testimonial: "Thank you so much. I just wasnt sure were the bolts were inorder to get off. That helped me a lot thanks!!! "
159 views
Usually answered in minutes!
×