I have a 1995 jeep wrangler and the reverse lights do not work

Your shifter may have come loose and slipped out of position. This video may help.

https://www.youtube.com/watch?v=hMGU_3CCUBg

the bulbs are old and prob needs replaced possibly bad connection gonna have to tear it apart check grounds and have multi meeter avail to test for power

ambient air temperature sensor try that most places charge 15 bucks for it and its on top easy to get next to the throttle body

Check the brake light switch on the brake pedal

that would be the first thing i would look at, check to make sure all vac lines are connected at actuators and switches, indicator light wont show until actuators have locked

Multifunction Switch is probably the problem

Could be one of several items...I'd check the fuel pump relay, auto shutdown relay and the ignition switch itself. I'd bet on it being one of those relays but, we all have been fooled at least once!!! I'd also make sure that body and engine grounding is good and clean. Relays can't work properly without a good ground.

check brakelighy switch

Raise vehicle, disconnect negative battery cable. remove two nuts and wires holding cables with approx 3/8 socket. It will probably be metric.

Then remove two retaining bolts holding starter. remove starter
Reverse procedure to reinstall.

For more information you can view your free online repair manual at;

http://www.autozone.com

http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%0900045_starterreplace.xml&subtitle=replace

are all dash lights out???