How to reset inspection light on 2000 bmw 323

There is really no torq setting for a wheel bearing, do it up till there isn't anymore movement in the wheel, make sure you have plenty of grease too, it's relatively a easy job to do, good luck

Check this video:
https://www.youtube.com/watch?annotation_id=annotation_505999&feature=iv&src_vid=wKYL9_4mXRI&v=DX9iCZIVgFY

About right what i do it disconnect the wire to the light then use a old heater glow plug relay and wire this into the ignition with output going to the light ,turn ignition on and 10 sec it goes out ,better than connecting it to oil light or or gen light ,ourvehicle inspectors know all the dodges us cowboys get up too when the annual inspection is due

Hi could be a fault with the charging system Alternator.

Check for a shorted brake light switch. The switch is under the drivers lower trim cover. It is an adjustable switch.

bmw vacuum liner? what'' that?

needs to be reset. Im sure a google search for the reset procedure for oil inspection is readliy available.

The way to reset any E46 BMW (3 series 1999-2005) is as follows:

Turn the car off and then hold in the odometer reset button on the left side of the dash. Turn the key to on but not start. Hold for a few seconds and the service reminder will show in the instrument panel. Release then double push the button and the service reminder will reset. If you just keep single pushing at that point, you will be surprised about all the information you can learn.

it sounds like it is either a weak battery or the solonoid on the starter motor

Hello Mike.

This means there is a faulty component. To reset the light in the first instance is a god idea but if it come on again then you need to have the code read to see which component needs to be replaced. In most cases its the seat belt tensioner that needs replacing due to wear and tear.