1996 Lincoln Continental Logo
Posted on Jul 25, 2008
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Air ride suspention front 1996 lincoln continental

Compressor no longer kicks in to raise front end ,dont know if its shocks or wher the air compressor is located to evn check it .there is power to the 20amp fuse located ondrivers side next to battery

  • chrisyescoba May 10, 2009

    i have a 1996 lic continental, i wanted to know if you know how much will it cost me the fix the air suspension, i think its the motor or pump when you turn on the car you can hear it tyring to work, we had the car on a ramp for a day or so and the car just wont lift up any. If you can please help or tell me a price

  • Anonymous Mar 19, 2014

    Need to know where the air compressor fuse is located?

×

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 2 Answers
  • Posted on Mar 17, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Mar 17, 2009
Answers
2
Questions
0
Helped
2003
Points
10

The air pump is located in front of the radiator reservoir on the passenger's side - with the power steering reservoir between the two.

The air ride is turned on in the truck. The panel in located on the opposite side from the gas tank input (inside the trunk) behind a door. It should be marked on the door.

Make sure the air ride is enabled. turn the ignition key on, You don't need to start the vehicle. After about 5 seconds the air compressor should engage. You don't always hear it when it's running well. Since the engine is off, you should be able to hear any leaks in the air system.

Possible causes:
Hole/crack is air spring
Hole or broken air line or coupling
Failed air compressor

The rear suspension should use the same air system. If the pump is 'out' then the rear will also fail to adjust, But since it is on a separate air-line and valve system, it will continue to operate when the front has air leaks. And vise versa.

One pump
Two suspension systems - Front/Rear
Four air springs - One for each wheel

Another possible problem:
Your front wheels have a censor to indicate the height of the vehicle from the ground (basically). If this come unclipped, your system will think It's too high and will not add air to bring it to normal height. This usually happens on ONE side causing the vehicle to 'lean' or seem to. One side will have the wheel up in the wheel well, and the other will be a bit more gap between the wheel and the wheel well, but may seem to be 'low' too. On the side which is lowest, turn the wheel that direction and look on the front of the suspension arm for the sensor. it should be attached top and bottom.

If the clips have failed, there are no replacements available from the dealer, and replacement of the sensor is required.

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Novelist:

An expert who has written 50 answers of more than 400 characters.

Sniper:

An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert 58 Answers
  • Posted on May 06, 2009
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Novelist:

An expert who has written 50 answers of more than 400 characters.

Sniper:

An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

Joined: May 04, 2009
Answers
58
Questions
0
Helped
71048
Points
174

It sounds to me like your compressor got killed. What probably happened is that the airbag got a hole or tiny crack in it so the compressor has to work extra hard because it is like blowing up a balloon with a hole in it. Therefor the airbag killed the compressor. I would recommend going to strutmasters.com and taking a look at our conversion kits. these convert you from the airbag to a powder coated American made steel coil spring that is guaranteed to last the life of the car. I added the link below so you can check it out.
http://www.strutmasters.com/lincoln-suspension-parts-s/1.htm

I hope I was of some help
Good Luck!!!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Needing repair manual for 1998 lincoln mark viii lsc. cant find the air ride suspention compressor

  1. NOTE: Air compressor and compressor air drier assembly is located ahead of the front RH wheel. It may be convenient to service the solid state compressor relay and the four air line connections by disassembling and carefully bending back the forward section of the RH front fender apron (16054).
  2. Raise vehicle on hoist. Refer to Section 00-02 . Suspension must be in full rebound.
    1. Remove wheel and tire assembly.
    1. Remove RH front fender splash shield (16103).
1helpful
1answer

My air shocks are down and i don;t know what fuse to look for

the fuse is it the right front relay/fuse box, 60 amps I think. Most likely the shocks leak, then the pump runs too much to keep them up, then the pump burns up and blows the fuse. There are companies that make a shock for the rear to delete the air ride, the air ride can cost a lot to get running again. shocks and compressor.
2helpful
1answer

I have a 1994 lincoln continental car. Hoe do I replace the suspention drier?

why do you want to replace it? As air is exhausted through it, it dires it out for the next use. it's part of compressor assembly.

1996 cont'l The air suspension system includes the following major components:
  • Air compressor to supply air to the air springs (part of front spring and shock and rear spring and shock absorber assemblies
  • Front spring and shock (3C098) and rear spring and shock absorber (5A965) at each corner of the vehicle
  • Four linear air suspension height sensors (5359): two rear and two front height sensors to maintain the vehicle at the proper ride height; only LH rear height sensor is used for air suspension.
  • Dual-mode front spring and shock and rear shock absorber assemblies with internal actuator.
All system functions are controlled by vehicle dynamics control module (5A919). This control module receives inputs from several different sources. These inputs include:
  • vehicle speed via multiplex communication network
  • ignition switch position
  • door position via multiplex communication network
  • height sensor position
  • air suspension service switch
  • engine rpm via multiplex communication network
  • ride and steering personality settings via multiplex communications network
Communications monitor system operation and allow diagnosis of any concerns that may develop in the system. System monitoring for the driver's use is provided through the instrument panel mounted message center indicator (10D898).
  • Diagnosis communication for the service technician is provided through the data link connector (14489) (DLC) under the instrument panel and Rotunda New Generation Star (NGS) Tester 007-00500 or equivalent.
The message center indicator will display AIR LEVELING DISABLED or CHECK RIDE CONTROL if the suspension system is not turned on or the vehicle dynamics control module detects a concern. If air leveling system disabled is displayed, check that air suspension service switch is in the ON position.
----------------------------------------------------------
Solenoid Valve Vent The vent solenoid valve operates as follows:
  • The vent solenoid valve allows air to escape from the system during venting corrections.
  • The valve is located in the air compressor cylinder head and shares a common electrical connector with the motor.
  • The valve is enclosed in the cylinder head casting, which forms an integral valve housing that allows the valve tip to enter the pressurized side of the system.
  • Air leakage past the valve tip is prevented by an O-ring seal.
  • The vent solenoid valve opens when a corner of the vehicle is high and the vehicle dynamics control module (5A919) determines lowering is required.
  • When the vent solenoid valve is opened, it provides an escape route for pressurized air.
  • However, the vehicle will not lower unless the air spring solenoid valves (5311) are also opened to allow air to leave the springs.
  • Lowering the vehicle corners requires the vehicle dynamics control module to open two solenoid valves, the vent and one air spring solenoid.
  • Air is exhausted from the spring and vents through the compressor air drier (5346).
---------------------------------------------------------------------------------------------
Section 04-05: Suspension, Computer Controlled 1996 Continental Workshop Manual
REMOVAL AND INSTALLATION Air Compressor and Drier Assembly Removal
  1. Turn air suspension service switch OFF.
  1. Disconnect electrical connector located on the air compressor.
  1. Disconnect two air lines from compressor air drier.
  1. Remove three fasteners retaining air compressor and drier assembly to radiator support, frame rail and fender apron.
1helpful
2answers

Front end drops down nom wont raise up . air ride

dose anyone know where the sensor on 03 bmw x5 front suspension are located.
0helpful
1answer

2000 continental air suspention not working

have your shocks checked. air suspension provides ride height and shocks control bounce from road bumps
1helpful
2answers

1997 Lincoln Continental Suspension Conversion Problem

It could be a wheel speed sensor that went out or something... When working with the wiring, something could have just gotten crossed or tapped to get these codes as well. The compressor shouldnt be running anymore if everything was tied off properly. Take it in somewhere and have the codes cleared and that should fix the problem hopefully. I know AutoZone has a reader, but I do not know if they have they ability to clear the codes.
I hope this helps.
0helpful
2answers

I would like to bypass the air compressor and manual inflate the air ride so that it stays up.how do i do that Dennis

you would have to unplug compressor and remove airline and tie in a valve like one off of airshocks.
it is usually the air springs that rot and start leaking. so you will probably still leak down. you can replace with coil springs and do away with air ride your continental has airride front and rear?

http://cgi.ebay.com/ebaymotors/Lincoln-Continental-Coil-Spring-Conversion-Shock-Shocks_W0QQcmdZViewItemQQcategoryZ33590QQihZ020QQitemZ300262870255QQrdZ1QQsspagenameZWDVW

this would do away with system all together
Not finding what you are looking for?

1,718 views

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...