SOURCE: 1998 Buick Century Signal Issue
Remove the bulbs one at a time and check for dirt and corrosion at the contacs inside the sockets.The corrosion will cause higher than normal resistence and will make the signal to flash rapidly.As this only happens to the right side only check the right side.
SOURCE: Bussmann Flasher for Saturn
The flashers are timed thru the hazzard switch. The hazzard switchneeds replaced. As for your other problems, has to be a body control module. The dealer will need to program this peice, as it holds the miles.
SOURCE: 1999 ford expedition turn signals not working
It is behind center of instrument cluster just above the accel pedal in the blower/flasher relay block,it is actually a relay on this vehicle.
SOURCE: 1997 sonoma turn signal flasher
The flashers are located behind the instrument panel trim, roughly between the base of the steering wheel and the ashtray, just to the left of the car lighter. To access the flashers, you need to at least loosen the lower instrument panel trim. Just under the steering column there are two screws with star heads. One to the left of the column and one to the right. You need to remove both of these screws. You will need to remove your ashtray. On the upper left corner of the hole left by removing the ashtray is a 9/32 hex head screw. You need to remove it. Once these three screws are removed you should be able to pull down on this portion of trim under your instrument cluster. When you do this it may cause trim around your instrument cluster to loosen that you can just pop back into place with your hand. You won't need to pull down to far on this trim piece as there are still some screws holding the bottom. You should be able to pull it down far enough to see the flasher units behind and just to the left of the cigarette lighter. There are two flasher units and I found that the one on the right is for the turn signals.On the left the other is for the hazard flashers. It may be a hand scraping experience to replace the flasher but it beats paying someone to do it for you. They are easy to recognize because the are silver and round metallic plug ins. The flasher unit on the left is for the emergency flashers and the one on the right is for turn signals. You can place the emergency flasher unit into the slot the turn signal unit belongs until you get a replacement. These flasher units are pretty cheap.
SOURCE: I purchased a signal flasher(round plug/two prong)
the turnsignal and four way flashers are beside each other,you will need to remove the glove box,they are in a black plastic case beside a large wiring disconnect and held by a plastic strap
219 views
Usually answered in minutes!
×