-
Mercury Master
4,390 Answers
- Posted on Feb 14, 2011
Re: 1997 mercury grand Marquis driverside rear window...
Usually this means you need a new window regulator.
Section 01-11: Glass, Frames and Mechanisms
1997 Crown Victoria, Grand Marquis Workshop Manual
REMOVAL AND INSTALLATION
Window Regulator, Power
Front Door
Removal
-
If front door window glass (21410) is in the down position and is inoperable, the following steps must be taken; if front door window glass is operational, go to Step 2.
- Remove front door trim panel (23942) and front door trim shield (237A04). Refer to Section 01-05 .
- Disconnect battery ground cable (14301). Refer to Section 14-01 .
- Disconnect window regulator electric drive harness connector.
-
CAUTION: Be careful not to strike or scratch front door window glass because it can break.
Remove window regulator electric drive retaining screws through holes.
- Remove window regulator electric drive (23394) from front door power window regulator.
- Raise front door window glass to full up position by hand and secure with tape.
- Go to Step 5.
- Remove front door trim panel and front door trim shield. Refer to Section 01-05 .
-
Remove front door window glass as described.
-
Disconnect window regulator electric drive harness connector.
-
NOTE: Use care not to enlarge sheet metal holes in the door inner panel.
Remove two 1/4-inch rivets retaining lower bracket of front door power window regulator to inner panel. Use drift punch to knock out center pins for each rivet. Using a 1/4-inch diameter drill, drill out remainder of rivet.
-
Remove three window regulator electric drive retaining screws from inside door to remove window regulator electric drive from front door power window regulator.
-
Remove two window regulator retaining nuts.
-
Remove front door power window regulator from front door (20124).
Installation
-
Lubricate regulator mechanism with Teflon® Lubricant E7FZ-19590-A or equivalent meeting Ford specification ESB-M1C111-A.
-
Install front door power window regulator minus motor (23208) into access hole in inner panel.
-
Position front door power window regulator using upper studs and tabs on window regulator electric drive mounting bracket.
-
Install rivets retaining front door power window regulator to door inner panel (1/4-20 x 1/2 inch screw and 1/4-20 nut and washer assemblies or equivalent metric fasteners may be used).
-
Install two upper front door power window regulator retaining nuts.
-
Install window regulator electric drive with three screws. Do not overtighten screws.
-
Connect the window regulator electric drive harness connector.
-
Install front door window glass.
-
Adjust front door window glass as described.
-
Install front door trim shield and front door trim panel. Refer to Section 01-05 1997 mercury grand Marquis driverside rear window - snorkelbobby_38.gifimages/snorkelbobby_38.gif" alt="snorkelbobby_38.gif" class="h_mi" />
×