I purchased a 2002 Kia Rios station wagon and when I press the button for the front windshield sprayer and It then sprays the rear window and when I press the rear window button it sprays the front. How do I reverse this so it works correctly?
How do I reverse it? Like wheres it located, and what do I need to do it? Thank youHow do I reverse it? Like wheres it located, and what do I need to do it? Thank you
Alrighty. Uhm, how do I switch them. Like what does it look like, what all I need for it? What tools do I needAlrighty. Uhm, how do I switch them. Like what does it look like, what all I need for it? What tools do I need
only two tubes coming from washer bottle locate washer bottle switch tubes they will be easy to remove if bottle not in an awkward placeonly two tubes coming from washer bottle locate washer bottle
switch tubes they will be easy to remove if bottle not in an awkward place
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try disconnecting the tubes from the spray head (under the hood). The press spray button, if nothing comes out, you have a bad pump. It liquid is pumped, then you need to clean or replace the spray heads - they are clogged or damaged
could be a clog in the line, or blockage at the spray tip, if its on a seperate switch from the front washers check to see if the pump is engaging while the button is pressed, if all washers are activated on same button it is probly the line or nossle tip.
Hey Barry, go to your local O'Reilly's, Autozone, or Advance Auto and tell them your issue and ask them for their recommendations..... they WILL help you and it will be much easier than listening and trying to understand what I (or anyone) says on here..
The rear wiper has its own pump motor. pull the hose from the wiper and have someone engage to see if there is a clog. do the same at the motor. if bo liquid comes out then its the pump. also check fluid level in reservoir as well as a possible secondary reservoir
your rear wiper motor might be faulty,in the front i would check your fluid level-if it is full and you hear the pump running-check your washer lines to see if they are pinched-usually around where the hood closes
check that the jet is not clogged.take a very thin piece of wire,like from a twist tie and clean the hole. maybe the hose is pinched or disconnected.if you spray the rear,you should hear the pump working.i have seen hoses come off and if you spray for 20 seconds,it may leak from the car
If it shoots from the pump without lines connected, then there has to be blockage somewhere. You mentioned you blew the lines out, did you blow directly back through nozzles themselves?
How do I reverse it? Like wheres it located, and what do I need to do it? Thank you
Alrighty. Uhm, how do I switch them. Like what does it look like, what all I need for it? What tools do I need
It's above the headlights..
×