2007 B9 Tribeca haedlamos keep going out after replacement....last about 1 week tops...and noI am not handling the bulb with my hands

Have you by any chance added any LED bulbs to it anywhere? Climate Control and lighting is controlled by the BCM (body control module), and strange anomalies can happen if none OEM LED replacement bulbs are added to the system. The computer network doesn't understand the feedback caused by LED Control Modules.

https://www.google.com/search?q=auto+electrician+near+me

..

this may be of help if you do not have the manual with the legend.

Interior Fuse Box Location 2006 2014 Subaru B9 Tribeca 2006 Subaru B9...

Dead short somewhere in system that this fuse covers. I'm assuming you're putting the correct amperage fuse in.

Radio volume control on 2008 Subaru Tribeca does not ...

www.fixya.com/.../t25735073-radio_volume_control_2008_subaru_trib...

Jun 7, 2015 - Radio volume control on 2008 Subaru Tribeca does not work, but remote volume control on steering wheel works. ... does not... Replace the volume control(rheostat) inside the radio. .... Oct 09, 2014 ' 2007 Subaru B9 Tribeca.

LOOK IN THE OWNERS MANUAL IN THE GLOVE COMPARTMENT,LOOK IN THE BACK INDEX OF MANUAL, LOOK UP BULB REPLACEMENT.IT WILL SHOW YOU HOW TO REPLACE FOG LIGHT BULB.USE LATEX WHEN CHANGING FOG LIGHT BULBS, BECAUSE LIGHT BULBS IS HALOGEN IF TOUCH WITH FINGERS OR HANDS, OILS FROM HANDS WILL CAUSE HALOGEN OVERHEAT AND BLOW OUT.

Your owners manual should have a detailed section on that.

http://www.elightbulbs.com/2006-Subaru-B9-Tribeca-Replacement-Light-Bulbs under car at fog light unscrew cap pull bulb out do not touch new bulb hold at bottom put back in same way

there are four screws 10mm holding lens to front frame right behind lens facing front of vehicle

replace them again and install with gloves on. Oils in your hands destroys these bulbs prematurely

Hello SUBY bro, kick me if I'm wrong but imho this should not be that complicated to require a schematic......Below is the reply I posted here on FixYa for another 08 Tribeca owner......Peace

We have an 05 Legacy and I've done this. Tribeca should be the same way: Look through the engine bay behind the light, you can locate the position by following the wires which actually connect to the bulb assembly. The bulb assembly ought to be removable with a 1/4-1/2 turn and pull motion. Be sure to not touch the replacement bulb with your bare hands. Your Subaru service ought to help you with this and not charge you......