My 02 chevy cavalier turns over but will not start. I have replaced ever thing i know that could be wrong.

2001 Cavalier Gauge Problem - YouTube

? 7:50


https://www.youtube.com/watch?v=RzilY3gxexA

Jun 22, 2011 - Uploaded by 04holmes1

My 2001 Cavalier gauges go out in a very strange way. The 2min describe the problem, then at 4:54 you can ...

2000 Cavalier electrical problem - YouTube

? 1:02


https://www.youtube.com/watch?v=o7NU0y09mOo

Feb 25, 2011 - Uploaded by kodykills

Heres my car, being a piece of crap. If you know what might be wrong, let me know! **UPDATE** The problem ...

2002 Chevy Cavalier Gauges: Electrical Problem 2002 ...

https://www.2carpros.com/.../chevrolet-cavalier-2002-chevy-cavalier-ga...

Electrical problem 2002 Chevy Cavalier 4 cyl Front Wheel Drive Automatic ... I have a 2002 Cavalier and the instrument cluster did not work after replacing the battery. ...My 2001 honda civic lx gauge cluster turns on then turns off then turns on ...

Chevrolet Cavalier Questions - Why do my gauges stop ...

A "funny" noise doesn't give much of a hint but the first thing you want to do is open the hood and make sure the belt is on and also tight. If so the problem could be be anything from the crankshaft positioning sensor to the alternator or even water in the gas and you will have to get the fault code to find what the problem is. If it is the belt that's not expensive to replace but you still need someone that knows what they're doing. Get a mechanic to look at it.

how old is your battery? that might be it also.

easiest thing is to search it on google and youtube. there are a lot of how to videos on there. May i ask what is wrong with your brakes?

Catayltic conveter plugged . Have someone do a back pressure test. Don't know where or how you came up with code P1702 , it's not a valid chevy code .

Possibly bad tpos sensor

Bad idle air control valve

Bad maf sensor

Check the computer codes first before spending any more money on it

Also do a compression check

And check your valve timing and ignition timing just in case.

your battery isnt holding enough charge to crank the starter.thats what the clicking is. try charging you battery for a good 8-10 hours, if it still does the same thing you'll need a new battery.

It is most likely the starter.

Make sure it is not binding/sticking where you pull the release cable.

Drench the entire works in WD-40. Push it back and forth until it moves with no resistance.

Make sure the part that hooks onto the latch hasn't come loose enough to not slide over when it makes contact.

If that doesn't work, take the whole thing off. You'll have to anyway to replace it. Chances are with it disassembled you'll see what's wrong.

the problem is the crank shaft position sensor ! I just replaced it on my wifes and it runs like new....